EDF EUROFIGHTER User manual

Our EDF EF2000 kit is intented to use with EDF 110 or 120 mm Or Turbine 6 kg thrust.
The model is prepainted in grey, if you want to reach a scale apparence you mustsand all the
parts and re-paint with appropriate colors.
The following instructions help you to assemble the model.
WING SERVO
The center of servo hole is positioned at 4 cm from the rear carbon spar,see photo
Make the hole and enlarge it accordling to your servo measurement
Install the servo in the wood support and make a hole for the horn

Make the hole for the horn

RETRACTS INSTALLATION
The center hole for wing retract is at 13 cm from the rear carbon spar
Make the pre-hole in the center at 13 cm and enlarge accordling to dimensions of your
retracts

Make the pre-hole for the nose retract from the top of fuselage

Enlarge it accordling to your retract
Make the holes for whells accordling to your dimensions

Make the hole for the servo wire of the rudder
For the edf installation or turbine installation you must create a wood formers to support it

Schuebeler 110 mm in position
Canard servo in position

The CG is located around 1 cm rear of the wing former spar support
You can adjust it accorling to your flying mode