Edge Lighting CDP User manual

Installation Instructions for Controller Dial with Power Supply
904-CDP_02
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: [phone]
Fax: [phone]
www.edgelighting.com
[email protected]
CDP
SAVE THESE INSTRUCTIONS!
- This instruction shows a typical installation.
IMPORTANT INFORMATION
© 2016 Edge Lighting. All Rights Reserved.
Installing CDP Panel
POWER SUPPLY
M
B
3
COVER
PHILLIPS SCREW
CASE
M
DVR-RGB-60
COVER
4
3: Loosen the six Phillips screws on front of the power supply to
remove the cover.
4: Carefully pull off the cover from the DVR-RGB-60 driver.
NOTE: This product requires deep double gang electrical box.
WALL
A
1: Connect the brown and blue wires of the 24VDC transformer
to the 120 volt hot and neutral wires with wire
nuts respectively.
2: Place the controller power supply inside the double gang
box.
NOTE: Before beginning any electrical work, ensure that power
to the electrical box is turned off.
DEEP SINGLE
GANG BOX
CONTROLLER
POWER
SUPPLY 120 HOT
120 NEUTRAL
1
2
1

C
ELECTRICAL BOX
CONDUIT
7
CONTROLLER
CONTROLLER
POWER SUPPLY
DMX CABLE (BELDEN #9841)
5: Connect the red wire of the power supply to the "VDC+"
terminal of the controller.
6: Connect the black wire of the power supply to the "Ground"
terminal of the controller.
7: Run the blue and brown line voltage wires coming from
the controller power supply to the power supply case.
8: Install conduits from controller, main panel (line voltage),
and soft strip to power supply.
9: Run proper DMX cable (Belden #9841 recommended)
with three data wires from controller to the power supply
box.
5
6
5
NOTE: Refer to the "Configuring DimWheel" & "Operating
DimWheel" for help on programming the Dimwheel.
M
M
POWER SUPPLY
D
M
10: Install a red wire from the power supply to DVR-RGB-60
"VDC+" red terminal and a black wire from power supply
to DVR-RGB-60 "VDC-" blue terminal.
11: Connect one end of a data wire (blue with white stripes
wire) to controller "LEDSYNC OUT–" terminal. Connect the
other end into the DVR-RGB-60 "DMX in –" terminal.
12: Connect one end of a data wire (white with blue stripes
wire) to controller "LEDSYNC OUT+" terminal. Connect the
other end into the DVR-RGB-60 "DMX in +" terminal.
13: Connect one end of a data wire (bare shield wire) to
controller "LEDSYNC SHIELD" terminal. Connect the other
end into the DVR-RGB-60 "DMX in shield" terminal.
10
EXT in-
EXT in+
VDC-
VDC+
DMX in + DMX in - DMX in shield LEDSync out +
LEDSync out- LEDSync out shield
12
CONTROLLER
DVR-RGB-60
POWER SUPPLY
12 DO NOT
USE
NOTE: For assistance wiring a fixture to LED Driver reference
fixture installation instructions.
M
Ext in-
Ext in+
DMX in +
DMX in -
DMX in shield
LedSync thru+
LedSync thru-
LedSync shield
Driver
VDC+
VDC-
MASTER LED
DRIVER
NOTE: "DMX in+", "DMX in-", "EXT in+" & "EXT in-", controller
terminals are not used on controller.
12
11
11
13
13
10
9
2

E14: Screw CDP unit onto gang box using provided screws.
WALL
NOTE: Reference operation guide for information on
programming CDP unit.
14
CDP
GANG BOX
3