Eiki AH-55201 User manual

Installation Manual
AH-55201
AH-55301
AH-55401
AH-55501
AH-55601
AH-55701
AH-55801
1
23
Press STANDBY-ON on the projector or on the remote control to
put the projector into standby mode.
•Disconnect the power cord and unplug the power cord from the AC
socket after the cooling fan stops.
Remove the lens cover.
•Press the lens cover removal button (1). Slide the lens cover forward
(2).
1
2
Turn the lens in the direction of the arrow while pressing the lens
removal lever to pull the lens out.
Do not attempt to exchange the lens
when the projector is installed
hanging from the ceiling. Injury may
occur if the lens cover and lens fall.
Before exchanging the lens, reset
lens shift to the center position. (The
lens shift is located at the center in
the factory preset.)
When resetting the lens shift to the
center position, press H&V LENS
SHIFT and then press UNDO.
•The lens shift reset screen will be
displayed. Select “Yes” to reset.
STANDBY-ON button
UNDO button
H&V LENS SHIFT
button
Power cord
Removal lever
WX5000_Lens_Inst_E.p65 08.5.20, 5:12 PM1

Printed in China
XXXXXXXXXXXXX
08PXX-CH-NM
6
54
7
Remove the lens cap from a replacement lens.
If you try to attach the lens to the projector
without removing this cap, the optional lens
attachment part can be damaged.
Info
Insert the hook of the replacement lens to the notch, and turn the
lens in the direction of the arrow.
•Make sure that the lens is locked with the lens removal lever when you
hear a click sound.
Slide and attach the lens cover.
•The power cannot be turned on unless the lens cover is fully inserted.
Select the correct lens type in “Lens Type” of “Menu”.
Note
•For details, see the owner’s manual
of the projector.
Attached lens
AH-55201
AH-55301
AH-55401
AH-55501
AH-55601
AH-55701
AH-55801
Lens Type
Type 1
Type 2
Type 3
Type 4
Type 5
Type 6
Type 7
EIP-WX5000, EIP-WX5000L
WX5000_Lens_Inst_E.p65 08.5.20, 4:57 PM2