
Technical Data:
-Peak Power output: 1.5 Watt
-Optimum working voltage: 17.5V
-Tested under standard condition: AM 1.5, lOOmW/c m2, Module at 25°C.
Important:
In some makes of vehicle, the cigarette lighter may not operate when the ignition is turned off. In such
cases, you can connect directly onto the battery using the alligator battery clamps and cable provided.
Please note that the black lead indicates negative (-) and the red lead indicates positive (+).
Ensure you connect to the correct battery terminals, if in doubt check with your local garage.
Assembly /
Location:
•Assemble the suction cups onto the charger.
•The charger can now be attached to the inside or outside of the car windshield.
•Connect the main cable to either the cigarette lighter socket or directly to the battery.
•Alternatively you can wall mount using the keyhole slots on the rear of the charger.
Operation:
As long as there is sufficient sunlight available, the charger will produce an electrical current to trickle
charge your battery. A LED is located in the edge of the case, this will flash blue whenever the battery
is receiving charge.
The charger will not damage or over-charge your battery. Similarly, a blocking diode ensures that the
charger cannot flatten your battery. Please note that the charger is designed to top-up battery charge
as a result of natural drainage. It is not intended to recharge a battery that has fully discharged.
Warning!
You must disconnect the charger from your cigarette lighter or battery when starting you engine or
driving. Electrical surges from the car engine when starting and running may damage your charger.
Note!
Some vehicles have tinted windows that will seriously affect the performance of your charger if it is
positioned behind them. For Optimum charging the unit should be placed outside the vehicle in direct
sunlight.
www.ekt2.com
Electronics Katrangi Trading