Elba EWDC-F0806IN User manual

For The Warranty Terms & Conditions, Please Refer To Warranty Certificate
Owner’s Manual
Please read this manual carefully before
operating your set.
Retain it for future reference.
Record model number and serial number
of the set.
See the label attached on the set and
quote this information to your dealer when
you require service.
WASHING DRYER COMBO
MODEL: EWDC-F0806IN(WH)

We recommend that you read the instructions in this owner’s manual carefully before using
it for the best performance and to extend the lifespan of your appliance, as it will provide you
with all the instructions you require to ensure its safe installation, use and maintenance.
1. SAFETY PRECAUTIONS
To ensure your safety, all electric appliances should only be installed or serviced by
qualified technician. If the supply cord is damaged, it must be replaced by the authorized
service center or similarly qualified technician in order to avoid hazard.
Do not place supply cord on the edge of table and counter, or near any heating appliance.
In order to avoid electric shock, do not immerse supply cord, plug or other parts into water.
Do not place the appliance near electric stove, heated oven or other heat source.
In order to avoid burning or risk of fire, combustibles or flammable material (curtains, cloth,
wallpaper and others) should be kept away from the appliance.
When the appliance is not being used, everything should be removed from the drum.
Accessible parts may become hazardous during use, please keep away from children.
Disconnect the appliance from the power supply before cleaning or maintenance.
When the appliance is faulty, please contact the authorized service center. Do not attempt
to repair by yourself.
Never use metal scouring pads or sharp scrapers which will damage the appliance surface
or interior wall, leading to scratches of the enamel.
In order to avoid hazard or electric shock, never put laundry exceeding the capacity.
Please make sure the power has been switched off when the appliance is not in used.
Unplug from the socket when you are planning not to use the appliance for long time.
2. ATTENTIONS
In order to avoid electric shock, please make sure the appliance has been shut off before
carrying out the maintenance.
Use only original accessories provided by ELBA or its authorized service center.
Do not use wet parts of the body to touch the appliance.
Do not pull the appliance by its supply cord.
The appliance should not be exposed to rain or direct sunshine.
Do not use or store flammable objects near to the appliance.
Always pull out the plug and cut off the water supply after the operation.
Check the water inside the appliance has been drained before opening its door. Do not
open the door if there is water visible.
The appliance shall not be installed in bath room or wet rooms.
Do not refill the water manually by hand while washing.
After the washing cycle is completed, please wait for three minutes to open the door.
Distributors decline all liability for not following above instructions or some improper operations
which caused personal injury and property loss.
1

3.INSTALLATION
3.1 Before the installation
Please check the products and make sure there is no damage on the appliance.
The appliance door is level, and you can open and close the appliance door flexibly.
Specification on the marking plate is in compliance with the regulations.
If the appliance appears in an abnormal way, do not install and unplug the power supply
before contacting the authorized service center.
Do not attempt to repair or service the appliance by yourself. Repair or maintenance
should only be carried out by a qualified technician or the authorized service center.
This appliance must be installed only by qualified technician or the authorized service
center. Manufacturer declines all responsibility for improper installation, which may harm
persons and cause damage to the property.
The AC power supply should be supplied with 220-240V, 50/60Hz with minimum 13A
distribution circuit fuse or circuit breaker.
3.2 Installation of the appliance
The material of the surroundings should be insulated, and the clearance between the edge of
the cabinet and the appliance should be over 100mm for ventilation.
Remove the transport bolts
Before using the appliance, transport bolts must be
removed from the rear of the appliance.
Loosen all bolts with a spanner and remove them.
Stop the holes with transportation hole plugs.
Keep the transport bolts properly for future use.
Adjust the bottom legs
When positioning the appliance, check if the legs are closely
attached to the appliance. Otherwise, please turn using hand
or spanner and tighten the nuts with spanner. Make sure the
appliance is in level with the ground and not move around
when pressed on top.
Connect the inlet and outlet pipe
Connect the elbow to tap and fasten it clockwise.
Connect the other end of inlet pipe to the inlet valve at the rear
of the appliance and fasten the pipe tightly clockwise.
Position the pipe as shown in the figure.
2

4.PRODUCT DESCRIPTION
5.ACCESSORIES
It can drain the water up and down, outlet hose
shall not be installed at a height beyond 100cm
and its end shall not be immersed in water.
3

6. HOW TO USE YOUR WASHING MACHINE
Detergents
“Low suds” detergent or washing powder shall be selected according to fibre type, colors,
washing temperatures, dirty degree and types.
Bleacher belongs to alkaline type can damage clothes.
Powder detergents can easily leave the residues in the clothes so as to generate the bad
smell; hence they shall be sufficiently rinsed.
Detergent cannot easily get dissolved completely if there is excessive or water
temperature is low. It can remain in clothes and pipes to pollute the clothes.
Washing shall follow the weight of clothes, dirtiness, local water hardness as well as the
recommendations from the detergent manufacturers.
Keep detergents and additives in safe and dry places out of reach of children kids.
Care on the garment
Please check the pockets of the clothes to be washed, empty the rigid items such as
decorations and coins, otherwise the appliance may be damaged.
The clothes to be washed are classified into cotton, blended fibre, synthetic fibre, silk,
wool and artificial fiber. Follow the symbol type and make sure the clothes are suitable to
wash in the washing machine.
White and colorful garments shall be identified. All new colorful articles shall be washed
in a separate way.
The articles of different sizes are washed together to increase the washing effects.
Soft articles shall be washed separately. As for new pure wool textiles, curtains and silks,
the soft washing procedure shall be selected. Check the labels in all washing articles.
The clothes shall be sorted before being put into washing machine. As for the curtains
with hooks, the hooks shall be removed before being washed.
The decorations on the clothes may damage the washing machine. As for the clothes
with buttons or embroideries, they shall be turned over before being washed.
Zips shall be zipped close and buttons or hooks shall be fixed. The loose band or ribbon
shall be bound together.
Confirm the washing capacity
Do not put excessive load into the washing machine. It may affect the washing effects.
Please confirm the maximum affordable washing quantity according to the following:
Fiber Type
Maximum Loading Capacity
8.0kg
Cotton
8.0kg
Synthetic
4.0kg
Wool
2.0kg
Washing machine shall not wash water-proof materials (ski suits, napkin pads, curtains).
Do not wash the fiber products that water cannot get soaked easily into such as
water-proof cushions and clothes. Otherwise there will be water bursting out or abnormal
vibration to cause danger and that the clothes also may be damaged. (Such as outside
napkin pads, raincoats, umbrella, ski suits, car covers, sleeping sacks etc.)
4