Electro-Voice ZLX-12P User manual

Electro-Voice ZLX Series Quick Start Guide Part Number: F01U280690 Rev. 01
Step Illustration
1. Connect the AC power cord from a grounded line
receptacle to MAINS IN.
2. Switch POWER to ON.
3. All input channels should be turned to the left before
connecting any jack.
4. Connect the 3.5 mm mini jack, XLR or TRS cable from an
audio source to AUX IN (A), INPUT 1 (B) or INPUT2.
A
Quick Start Guide for ZLX-12P and ZLX-15P Loudspeakers
A. ZLX-12P unit, 12” Two-Way Powered Loudspeaker
OR
ZLX-15P unit, 15” Two-Way Powered Loudspeaker
B. ZLX Series Loudspeaker Owner’s Manual
C. Power Cord
Instructions
A CB
Packing List
A
B

Electro-Voice ZLX Series Quick Start Guide Part Number: F01U280690 Rev. 01
Step Illustration
5. Push and hold DSP knob to select application MODE
and LOCATION. Select EXIT to return to the home
screen.
6. From the DSP home screen increase the input gain knob
(C) while viewing the VU meters. (D) To ensure proper
gain structure signal present will peak at no more than
75% in the VU meters. Decrease gain by turning the knob
to the left to avoid clipiing if to much signal is present.
7. Slowly adjust MASTER VOL to the desired volume.
Instructions—Pole Mounting
Step Illustration
1. Ensure the pole is firmly in place.
2. Use two hands to lift the loudspeaker with the hi/lo grip
handles.
3. Set the pole cup located on the bottom of the
loudspeaker onto the pole.
4. Tighten the thumb screw to secure the loudspeaker to
the pole.
D
C