Electrolux ECS9691G User manual

ECS9691G
ECS6691G

8
9
10
11

Fig.4
5
600/900
420
480350
278
276
ECS9691G
ECS6691G
ECS9691G
ECS6691G
10
9
6
7
Chimney
Oil cup
Aluminum pipe
Hood mounting bracket
5Mounting screws(ST 5X 50MM)
5Drywall Anchors
DamperDamper
set
8
9
10
1Duct fixing tape
1User manual
Fig.3

700
460mm
Min.830
Range hood
mounting points
Fig.5
(Fig.5)
Install the wall bracket with screws to the wall as
marked(Fig.6) .
Hang the hood on the wall bracket(Fig.7).
Fig.6
Fig.7
Fig.8
(Fig.8)
tapes

Self-clean
Self-clean instruction
This product is equipped with self-clean technology.
The self-clean icon will start glowing after the motor
works for 15hours. User can tap the self-clean button to
active the self-clean function.
The red indicator will start glowing during the cleaning
process.
The time period for Self-clean is 10 to 15 minutes. The
product can be used during self-clean.
Assemble the flue cover onto the hood body make sure
it on the correct position.
Fig.9
(Fig.9)
Glass
●Glass should be cleaned every week in order to
keep the shiny
Grease filter
The grease filter should be cleaned frequently (
every two months of operation, or more frequently
for heavy use). Use a warm detergent solution.
Grease filter is washable
Remove the grease filter by unscrewing the screw
on the rotation support and releasing the glass
panel from two hinges . Tilt the filter downward and
remove(Fig.10)
Wash the filter , taking care not to bend them.
Allow them to be dried before refitting.
To install the grease filter , push filter into position
and release . Fix the glass panel to the two hinges
and refix one screw .
Note: To replace the filter, please let the hood on
suction mode beforecutting off the electrical
supplier and don't open the glass panel by hand.
●
●
●
●
●
Replacing the lamp
Dismantle the lower glass by removing the two rubber
columns and unscrewing the two screws on glass(Fig.11).
Replace the damaged LED, only use LED DC 12V,2W Max
Note:
1.To replace the LED, please let the hood on suction mode
before cutting off the electrical supplier and don't open the
glass panel by hand.
WARNING: .
1. Always switch off the electrical supply before carrying
out any operation on the appliance.
2. Only a qualified and trained service technician can
undertake the work of bulbs replacement and servicing.
2.We recommend only using lamps of the same
specification as the ones being replaced.
Fig.10
Fig.11
Changing the lamp

Philippines
Consumer Care Center Toll Free:
1-800-10-845-CARE(2273)
Consumer Care Hotline:(+63 2)845-CARE(2273)
Electrolux Philippines,lnc.
Unit B 12F Cyber Sigma Bldg, Lawton Avenue,
McKinley West,Taguig, Philippines 1634
Trunkline:[phone]
Website:www.electrolux.com.ph
Email:[e-mail]
Vietnam
Consumer Care Center Toll Free
1800-58-88-99
Tel: [phone]
Electrolux Vietnam Ltd.
Unit 1&2, 10F Sofic Tower, #10 Mai Chi Tho
Street,
Thu Thiem Ward, Thu Duc City, Ho Chi
Minh City, Vietnam