Electrolux WRH605I Series User manual

RETRACTABLE RANGEHOOD
OPERATION GUIDE
INSTALLATION INSTRUCTIONS
Models: WRH605I • WRH608I • WRH908I • REHR6 • REHR9 • RRE634 • RRE635 • RRE934
These cooker hoods are domestic appliances which have been manufactured and tested to comply with
Australian and New Zealand Standard AS/NZS 3350.2.31.
13427_Rangehood_Electrolux.indd 113427_Rangehood_Electrolux.indd 1 3/11/05 6:28:19PM

RETRACTABLE RANGEHOOD
Safety Warnings
•This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or insruction
concerning use of the appliance by a person responsible for their safety.
•Children should be supervised to ensure they do not play with the appliance.
•Ensure the cooker hood is switched off before carrying out maintenance, to avoid any possibility of electric shock.
•Grease filters must be removed every four weeks (maximum) for cleaning to reduce the risk of fire.
•Do not flambé under the cooker hood.
•This cooker hood is not recommended for barbeques.
•The exhaust air from the cooker hood must not be discharged into any heating flue, which may carry combustion
products from other sources.
•Exhaust air must not be discharged into a wall cavity, unless the cavity is designed for the purpose.
•There must be adequate ventilation of the room when the cooker hood is used at the same time as appliances burning
gas or other fuels.
•Always cover lit gas burners with pots or pans when the cooker hood is in use.
•Always switch off gas burners before you remove pots or pans.
Cleaning
Wipe the cooker hood body and flue with a sponge or soft cloth soaked in warm soapy water. Do not use oven cleaners
or other abrasive materials.
Electrical Connection
•Check that the mains voltage matches with the voltage on the data plate inside the cooker hood.
•Check that the installation complies with standards of local gas and electricity authorities.
•If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.
Accessories
•Use 125mm round exhaust ducting for best performance.
•When using flexible duct always install duct with the wire helix pulled taut to minimise pressure loss.
•Try to keep exhaust duct short and straight.
•Keep bends in the exhaust duct to a minimum.
•Do not reduce the size or restrict exhaust duct.
P1
13427_Rangehood_Electrolux.indd 2
•CAUTION: Accessible parts may become hot when used with cooking appliance.
•Regulations concerning the discharge of air have to be fulfilled.

Please read instructions carefully. Service calls resulting from incorrect installation will be charged for.
Exhaust air from the Rangehood must not be discharged into any heating flue which may carry
combustion products from other sources. In addition, exhaust air must not be discharged into a wall
cavity, unless the cavity is designed for the purpose. Adequate ventilation of the room must
be ensured when the Rangehood is operating simultaneously with appliances burning gas or
other fuels. Installation must comply in all respects with your gas and electrical authorities. This
Rangehood is an indoor domestic appliance, and has been manufactured and tested to comply with
Australian and New Zealand Standard AS/NZS 3350.2.31
It is recommended that the unit be positioned as close as possible to 600mm (electric hobs),
650mm (gas hobs), and no further from the hob than 800mm. The unit becomes less effective
as the distance from the cooking surface to the hood increases.
FIXING POINT DIMENSIONS - 600mm Retractable cooker hood
FIXING POINT DIMENSIONS - 900mm Retractable
cooker hood
INSTALLATION INSTRUCTIONS
600
650
GAS
ELECTRIC
Ducting hole
cover
Duct Spigot
DUCTING INSTALLATION
When installing with ducting pipe the Duct
spigot must be fitted to the ducting hole
on top of the body of the cooker hood
RECIRCULATING INSTALLATION
(For Models: WRH608, RRE634, RRE635, WRH908
& RRE934)
When installed in recirculating mode the
ducting hole cover must be fitted
P2
13427_Rangehood_Electrolux.indd 313427_Rangehood_Electrolux.indd 3 3/11
OPERATION GUIDE & INSTALLATION INSTRUCTIONS
The maximum space between the wall and screw cap is 5mm.

RETRACTABLE RANGEHOOD
STANDARD DUCTED INSTALLATION
Models: WRH605I • WRH608I • WRH908I • REHR6 • REHR9 • RRE634 • RRE635 • RRE934
DUCTING ACCESSORIES
For best performance 125mm ducting is recommended.
INSTALLATION INSTRUCTIONS
AR125RC
AR125F
AR125FD
AR125B
AR125FJ (without damper)
AR125FJD (with damper)
AR125WV
P3
13427_Rangehood_Electrolux.indd 4
Accessories can be bought through your local appliance retailer,
or in Australia online at: shop.electrolux.com.au

OPERATION GUIDE & INSTALLATION INSTRUCTIONS
INSTALLATION USING THE SUPPLIED DRAWER FASCIA
FOR MODELS: WRH605I WRH608I WRH908I REHR6 REHR9 RRE634 RRE934
Standard ducted installation calls for a door extension of 130mm
whether the client opts to use the supplied draw fascia or a custom
fascia of the same dimensions as that supplied.
RECIRCULATING VENT INSTALLATION
Note: If the Rangehood is to be vented using the recirculating vent rather
than standard ducting, the supplied drawer fascia is not to be used
and must be replaced with a client specific custom fascia**.
The custom drawer fascia must be a minimum of 70mm deep as air
expelled through the recirculating vent must be deflected upwards.
INSTALLATION INSTRUCTIONS
130
40 3
101
70 3
RECIRCULATE
EXHAUST
RECIRCULATE
EXHAUST
Setting of circulation air door - single fan models Setting of circulation air doors - dual fan models
P4
13427_Rangehood_Electrolux.indd 5
Unscrew and remove
cover from
recirculating vent
● ● ● ● ● ●
FOR MODELS: ( WRH608I WRH908I RRE634 RRE934 )** (RRE635 already fitted with 70mm front panel)
● ● ● ●

RETRACTABLE RANGEHOOD
P5
INSTALLATION INSTRUCTIONS
AR125WV
DUCTED RECIRCULATING INSTALLATION
FOR MODELS: REHR6* REHR9* WRH605I*
ALL MODELS OPTIONAL CARBON FILTER
An optional carbon filter will diminish cooking odours in the recirculated air.
Depending on the frequency of use and the type of cooking, the expected life of carbon filters is from 1 to 6 months.
Replacement is required.
Recirculating accessory:
Optional carbon filter ARCFD for recirculating mode only.
13427_Rangehood_Electrolux.indd 613427_Rangehood_Electrolux.indd 6 3/11/05 6:28:21M

OPERATION GUIDE & INSTALLATION INSTRUCTIONS P6
OPERATION
MODELS: WRH605I* REHR6* REHR9*
The operation of the light and the two-speed fan are controlled by the drawer action. (see diagram)
IMPORTANT: The Edison Screw lamps may have come loose during transportation.
Ensure that lamps are tightened firmly into the socket before power is applied.
MODELS: WRH608I* WRH908I* RRE634* RRE635* RRE934*
The operation of the lights and the three speed fans are controlled by the drawer action. (see diagram)
OPERATION & MAINTENANCE
MAINS SWITCH
OFF
TO REPLACE LIGHT GLOBES
1. Open drawer and remove filter.
2. Turn mains switch off before removing lamp.
Replace with 40W maximum E14 candle lamp. Depending on model will require 1 or 2 globes.
13427_Rangehood_Electrolux.indd 7

RETRACTABLE RANGEHOOD
OPERATION & MAINTENANCE
MAINTENANCE
To maintain efficiency and reduce fire risk, filters should be removed every four weeks (maximum) for cleaning. Soak and
agitate filters in hot soapy water or washing soda. Rinse, drain, shake well and replace.
Do not use caustic solutions or other corrosive agents.
The filters can be washed in the dishwasher, but could dis-colour caused by dishwasher cleaning agents. It is
recommended the filters be placed on the top shelf of the dishwasher.
NOTE: Where fitted, optional carbon filters are intended to be a disposable item and should be discarded when saturated.
Washing the carbon filter is not recommended.
REMOVE FILTERS FOR CLEANING
1. Slide filter tray forward 1cm.
2. Push in clip on either side to release filter. Fig 1.
3. Pull filter downwards to remove. Repeat 2 & 3 for models with a second filter. Fig 2.
4. Turn off mains switch before cleaning drawer and cooker hood body.
5. After cleaning, re-fit filters making sure the clip pins are securely fitted into the locating holes in the cookerhood body
and for twin filter versions, also located in the pull out drawer section.
6. Holding clip in, push opposite side of filter up until pins are over locating holes.
7. Release clip ensuring filter is securely fitted.
Safety Tips: Use of two hands for removal and re-fitting of filters is recommended to avoid accidental dropping of filters
which could cause damage to your cooktop or kitchen surfaces.
Should you require further instructions in the use and care of your cooker hood please contact the Customer Care Centre
on 1300 363 640 (Australia, Mon-Fri 8.00am-5.00pm Eastern Standard time) or [phone] (New Zealand, Mon-Fri
8.00am-5.00pm). If you have a warranty or spare parts enquiry, you should call the number listed on the warranty page.
PRESS
Fig 1.
Fig 2.
P7
13427_Rangehood_Electrolux.indd 813427_Rangehood_Electrolux.indd 8 3/11/05 6:28:21PM

RETRACTABLE RANGEHOOD
NOTES
13427_Rangehood_Electrolux.indd 1013427_Rangehood_Electrolux.indd 10 3/11/05 6:2