Electrovision T143EC User manual

T143EC
Remote Control Outdoor Television
DAB & FM Radio Aerial with
amplifier
Ideal for caravans, boats and mobile homes
Built-in auto-gain amplifier
Receives local 1080 Full HD-TV, DVB-T TV, DAB
radio and VHF FM radio.
Signal clear technology with extremely low-noise
circuitry
Page 1

IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of
the product for future reference.
BEFORE USE
You must inspect the product including its cable and plug for any
signs of damage. If the product is damaged, DO NOT use it, and
contact your supplier immediately.
INSTALLATION
1.Attach the aerial to a mast of between 30 mm and 40 mm
diameter (not supplied).
Make sure that there is a
space of at least 500 mm
around the mast for the
aerial to rotate.
2. Extend the telescopic
antenna if VHF radio
reception is required.
3. Connect the aerial to the "antenna" socket on the control unit,
making sure that the cable is not fixed so tightly that it prevents the
aerial from rotating.
4. Connect the television or radio to either of the "TV" sockets on
the control unit.
5. Plug the 230V AC power supply into a 13A socket, and connect
its output lead to the 12V AC input socket on the control unit. The
230V AC power supply must be located indoors.
Note: This appliance will not work from a 12V DC supply.
6. Fit two AAA batteries into the remote control handset.
Page 2

OPERATION
Pressing either of the two buttons on the remote control handset
will cause the aerial to rotate.
The > button selects clockwise rotation, and the < button selects
anticlockwise rotation.
Alternatively, press the " ROTATING " button on the control unit. To
make the aerial to rotate in the opposite direction, release the
button and press it again.
Using the control buttons rotate the aerial until it receives the best
signal.
You can find the location of your nearest transmitter at
http://www.ukfree.tv/transmitter.php
If there is an obstruction in the direction of the transmitter, then
pointing the aerial slightly to one side of the obstruction may result
in improved reception.
• This aerial is intended for use with analogue and digital television
receivers in Band II,III, IV and V (88MHz to 860MHz), covering the
VHF and DAB radio and UHF television bands.
• It can be used for both analogue and digital television. A Freeview
convertor ("set-top box") will be required to use an analogue
television in areas where only digital television is broadcast.
• This is a wideband aerial, so can be used whenever Group A,
Group B, Group CD, or Group W aerials are specified.
DISPOSAL AND RECYCLING
You must not dispose of this aerial with domestic household waste.
Most local authorities have specific collection system for appliances
and disposal is free of charge to the end-user.
When replacing an existing aerial with a similar new appliance your
retailer may take the old aerial for disposal.
Page 3

TECHNICAL SPECIFICATION
Dimensions: 630×350×120 mm
with FM antenna extended: 630×1180×180 mm
Weight: 0·9 kg
Material: plastic
Connection: TV coax connector
Band: II/III/IV/V
Group: W
Operating frequency: 88 - 860MHz
Gain (VHF): 20 dB
Gain (UHF): 35 dB
Impedance: 75 W
SERVICE WARRANTY
Electrovision guarantees the product free from defects in materials
and workmanship for a period of twelve months.
Should this unit be operated under conditions other than those
recommended, or any attempts made to service or modify the unit,
then the warranty will be rendered void.
The product you buy may sometimes differ slightly from illustrations.
This warranty is in addition to, and does not affect, your statutory
rights.
If you have any problems with this product, please call our Help Desk
on (0845) .
Electrovision Ltd.,
Lancots Lane, Sutton,
St. Helens, Merseyside.
WA9 3EX
website: www.electrovision.co.uk
Page 4