Eleiko POWERLIFTING SQUAT STAND/BENCH User manual

ELEIKO POWERLIFTING
SQUAT STAND/BENCH
Art.no. 3060892-XX

CAUTION
The equipment must be installed and used in a place whose access and supervision
are specifically controlled by the owner.
Be sure to install the equipment on a stable base and properly level the equipment.
ELEIKO recommends that all equipment is secured to floor and installed by a licensed
contractor or an ELEIKO-installer.
SAFETY INSTRUCTIONS
It is the responibility of the purchaser of ELEIKO products to instruct all users and
supervising personnel on proper usage of the equipment.
1. All included warnings (labels) and instructions MUST be read before the use of any
ELEIKO-equipment. Use each equipment as it is intended for.
2. A user MUST get a medical examination and proper instructions before the use of
any ELEIKO-equipment.
3. DO NOT let anyone, under any cuircumstances, use equipment that appears to be
damaged. Do not try to repair any equipment before consulting an ELEIKO technician.
4. DO NOT replace the components of ELEIKO-equipment with other none ELEIKO-
equipment (magnetic safety pin, frames, bars), do not improvise. If there are any
doubts consult an ELEIKO representative prior to any intervention.
5. DO NOT overload the equipment and DO NOT try to exceed personal strength
levels.
6. Children under the age of 14 must be supervised by an adult.
7. DO NOT remove any safety labels from the ELEIKO-equipment. ELEIKO is not
responsible if a label is removed. Replace damaged labels immediately.
PREVENTITIVE MAINTENANCE & INSPECTIONS
DAILY:
Cleaning of upholstery.
REGULARLY:
Clean the surfaces on frames and tubes from dust and dirt.
Check that all bolts between parts, walls, floors are properly tightened, according to
recommendations.
ADDITIONAL INFORMATION
This equipment is for indoor use only.
READ BEFORE INSTALLATION AND USE

Nut M12
x2
Small parts
x2
M12 x 100
Washer 10
x10
M10 x 25
x10
Knob internal thread
x2
Knob externa thread
x4
Washer 6
x6
x6
M6 x 25
Assembly section
x1
Safety pin
x6
Tools needed:
Hex Key 6 mm
Hex Key 4 mm
Wrench 19 mm (x2)
CONTENTS

x8
Washer 10
x8
Screw M10x25
x1
Assembly section
1.
Do not overtighten the screws,
until all screws are set.
ASSEMBLY INSTRUCTIONS

M12x100
M12x100
x2
Nut M12
x2
Screw M12x100
2.
Make sure the bigger half
moon is facing inwards.

x4
Safety pin
3.

x2
Knob externa thread
4.

Washer 6
M6x25
x6
Washer 6
x6
Screw M6x25
x2
Washer 10
x2
Screw M10x25
Washer 10
M10x25
5.

Safety pin
x2
6.

Knob internal thread
x2
7.
Make sure to tighten all
screws and nuts regularly!

rev. 1803
Eleiko Group AB | Klastorpsvägen 18 | SE-302 62 HALMSTAD | Sweden
E-mail: [email protected] | Phone: [phone]
www.eleiko.com