Elenco Electronics XP-100 User manual

Battery Eliminator
Power Supply
Instruction
Manual
Model XP-100
Elenco Electronics, Inc.
150 W. Carpenter Avenue
Wheeling, IL 60090
[phone]
http://www.elenco.com
e-mail: [e-mail]
Revised 2001 REV-B 753264
SCHEMATIC DIAGRAM
Battery Eliminator
Model XP-100

INTRODUCTION
The XP-100 is a solid state DC power supply designed to give the
most popular battery voltages. Voltages are precisely set by using
1% resistors. A special IC circuit keeps the output voltage within
.2V of setting when going from no load to one ampere. The output
is fully protected from short circuits and overloads.
OPERATING INSTRUCTIONS
1. Check the voltage rating of the equipment to be powered. Care
must be taken not to exceed the rating.
2. Plug the line cord into a 120V 60Hz AC outlet.
3. Adjust the voltage control to the desired voltage. Load variation
will have practically no effect on the voltage setting due to the
special regulation circuit.
4. Connect the positive lead of your equipment to the red output
terminal and the negative lead to the black terminal.
5. Care must be taken not to exceed the current rating, as the
supply will turn itself off if overloaded.
SPECIFICATIONS
Input Voltage 120VAC
Output Voltages 1.5, 2.2, 3, 4.5, 5, 6, 7.2, 9, 10,
12, 13.8, 15 volts DC.
Accuracy +5%
Output Current 1 Amp max.
Line Regulation 105V to 135V
Load Regulation .2V(max) 0-1Amp
Ripple Max. .005V RMS at rated current
DC Current / Short Protection IC thermal cutoff
AC Short Protection 2A Fuse
Output Impedance .025Ω
TWOYEAR WARRANTY
All Elenco models are guaranteed for two full years
on all parts and service. For the first 3 months,
your power supply is covered at absolutely no
charge. For the remaining 21 months, a nominal
service charge is required to cover shipping and
handling.
When returning merchandise for repair,
please include proof of purchase, a brief letter
of explanation of problem, and sufficient
packing material. Before returning any
merchandise please call our service
department at [phone] to obtain a
return authorization number (RMA).