Elinta CityCharge User manual

To start charging:
1) Connect charging cable to electric vehicle;
2) Connect charging cable to charging staon;
3) Put the RFID idencaon card to the right place. The charging will start aer few seconds.
LED strips indicates status of charging staon:
• Blue – ready / charging nished;
• Red – staon is busy / charging electric vehicle.
Charging cable is locked during the vehicle charging. When the vehicle is fully charged the charging
stops automacally, or it can be stopped by using RFID idencaon card.
The place to use RFID card.
A/B indicaon is lightning in red during the
vehicle charging.
A/B indicaon is lightning in blue when the
charging is nished.
“READY” indicaon lights on when the
charging is nished.
“CHARGING” indicaon is lightning during
the vehicle charging.
LED screen
CityCharge
User manual
Elinta Charge, UAB
Parzanu g. 63M,
Kaunas 50306
Lithuania
Tel.: [phone]
[email protected]
www.elintacharge.com

CityCharge
Legal informaon
User changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.