©4Copyright420164ELITE®4
Kitchen4Storage4Solu@ons4 www.ELITEKitchenStorage.com4
STEP 1: Mount frame to cabinet base
Front of cabinet
Position frame on cabinet
floor (see diagram)
Affix saddles (1) to frame
using screws (2) and screws
(3) – (see diagram)
STEP 2: Affixing side stabilisers
Adjust the stabiliser width to suit
cabinet width.
Attach stabiliser to
frame using part 4 or
part 5 screw to suit
cabinet
NOTE: It is recommended to install the stabilisers to enhance the stability of the installed product
STEP 3: Affixing door
Mounting the cabinet door to the frame allows the bin set
to slide out when the cabinet door is pulled out
Position door brackets Attach door to mount
Models: ELITEPOB-600TWIN-219 and ELITEPOB-600TRIPLE-499
• If you are not attaching a door then it is recommended
you affix the part 7 nuts and bolts into the 3 mounting
holes on each side of the frame for enhanced stability
• A door mount kit can be purchased and affixed to
frame and mounted to door as per below
Models: ELITEPOB-600TWIN-219-D and
ELITEPOB-600TRIPLE-499-D
• Affix the door brackets to the back of the cabinet door
so that it will be in alignment (see diagram)
• Affix the door mount (attached to bin frame) to the
door brackets (see diagram)
• Make horizontal, vertical and tilt adjustments to fine-
tune the alignment of the door
Domes&que)68L)Twin)/)Triple)Slide)Out)
Concealed)Waste)Bin)
>)for)a)600mm)Cupboard)
