ELKOR ETBAC User manual

ETBAC Installation Guide
The ETBAC module must be configured before use!
Requirements:
•PC with web browser
•CAT5 Crossover cable
or
Ethernet HUB or Switch
Access the ETBAC confi uration screen usin your internet browser as follows:
1. Connect the crossover cable to the ETBAC, or plu it directly into the Ethernet HUB or
switch.
2. Connect the ETBAC to a 12-30VAC/VDC power supply.
3. Plu in the PC or laptop to the hub (or directly to the ETBAC if usin a crossover cable).
NOTE: Many modern Ethernet ports on PCs have auto-crossover detection and it may be
possible to use a standard CAT5 cable in this case, althou h it is not uaranteed.
4. Ensure that there is only one PC attached the the HUB in this small LAN.
5. Observe the li hts on the hub and ETBAC to ensure that a link is made. The upper-left
LED on the RJ-485 connector will li ht reen when a link is made. This may take a few
seconds after power up, as the device needs to boot up.
6. Set your PC’s IP Address to 192.168.88.90, with a subnet mask of 255.255.255.252.
Refer to your operatin system specifics as to how to set a static IP Address. A ood
reference is available here:
http://www.elkor.net/articles/static_ip
7. Open your web browser to the followin URL:
http://192.168.88.89
8. You will be prompted to lo in to the device “BACnet Device Websetup”
9. The default user is admin and the default password is admin
10. From the browser interface, you can chan e the IP confi uration usin the “BACnet/IP
Settin s” menu.

Once settin s have been chan ed, you much Activate Confi uration for the chan es to
take place.
11. Once the settin s have been activated, the device will reboot. You may place the device
on the intended LAN/subnet. Ensure you can pin the device from a command prompt.
Additionally, the confi uration web pa e may now be accessed via the newly assi ned IP
address (provided it is on the same LAN).
12. The device is ALWAYS accessible at IP address 192.168.88.89, therefore, if the device
cannot be reached usin the new settin s, or is in an unknown state, repeat steps 1-10
to reset to a know IP confi uration.
Device Pass ord
For security purposes, it is recommended to chan e the device password.
HOWEVER note that the password is not recoverable by ANY means.
This means that if the password is lost, it is impossible to retrieve, even at the factory.