Elm Plus HDPE FOLDING ADIRONDACK CHAIR User manual

Assembly Instruction
HDPE FOLDING
ADIRONDACK CHAIR
Elm Plus, LLC

1
PRE-ASSEMBLY PREPARATION
WARNING! DO NOT LET CHILDREN PLAY IN OR AROUND THE UNIT DUE TO THE POSSIBLE RISK OF FINGER ENTRAPMENT
• Please read through this instruction before beginning assembly.
• Two adults assembly is recommended.
• Clear out the space for assembly and lay out all parts base on Parts List, extra room will allow you to easily
determine if all the pieces are present.
• Save all packing materials until assembly is complete to avoid accidentally discarding smaller parts or hardware.
• Keep small parts and pieces away from children until fully assembly.
• Do not fully tighten the bolts until all have been inserted and hand tightened.
• Please check for any loose screws and tighten them before use.
PANEL AND FITTINGS IDENTIFICATION
Qty: 1
Qty: 1
Seat Panel (A) Right Arm Panel (D)Backrest Panel (B)
Left Foot Panel (E)
Left Arm Panel (C)
Right Foot Panel (F) Seat Panel (G) Connecting Rods (H)
Qty: 1 Qty: 2
Qty: 1 Qty: 1 Qty: 1 Qty: 1
Back Support Panel (I) Screw (K) Screw (L)
Qty: 1 Qty: 2 Qty: 4
HARDWARE LIST
M6 x 45mm
M6 x 40mm
M6 x 60mm
Screw (J)
Qty: 6
M6 x 60mm
Screw (M)
Qty: 4
TOOLS & MATERIALS NEEDED
10mm

A
E
F
J
J
K
KI
M
M
G
Note: Do not tighten all screws until last step.
Note: Do not tighten all screws until last step.
STEP 1
Attach Left Foot Panel (E) and Right Foot
Panel (F) to Seat Panel (A) by using 2 Screws (J).
Then attach Back Support Panel (I) to behind seat
part by using 2 Screws (K).
STEP 2
Attach Seat Panel (G) to two side foot panel by
using 4 Screws (M)

B
J
J
H
L
L
L
D
C
J
J
L
Note: Do not tighten all screws until last step.
Note: Do not tighten all screws until last step.
STEP 3
Attach Backrest Panel (B) to Seat Panel (A) by using 2 Connecting Rods (H) and
2 Screws (J) and 2 Screws (L)
STEP 4
Attach Left Arm Panel (C) and Right Arm Panel (D) to both side foot panel and backrest panel by
using 2 Screws (J) and 2 Screws (L)

4
STEP 5
Insert two side bolts in place to keep chair from swinging.
STEP 6
Pull out two side bolts to make it floded.
Note: Please tighten the screws before use.