1
2
Button
Rotate the display mounting plate back as far as it will go. Remove the lower plastic cover to expose
the VESA mounting holes by pressing the button and sliding the cover down. Then slide the upper
cover o the mounting plate.
Secure the I-Series 4 Slate Display to the stand by installing the M4x6 at-head screws (4 included
with stand kit) through the mounting plate and into the back of the display. Do not use longer or
shorter screws. Slide the plastic top cover over the mounting plate making sure the cover sits against
the rear of the display. Then slide the lower cover up until the button snaps in place.
3
5
4
Remove the cable cover door and route the USB-C cable from the I-Series 4 Slate Display under the
stand opening and connect to the USB-C port on the rear of the display.
Secure the USB-C cable on the back of the I-Series 4 Slate Display with the cable security bracket.
Replace the cable cover door.
Loosen the screws holding the cable strain relief bracket and temporarily remove the bracket. Route the
cable up through the bracket mounting area and reinstall the bracket to hold the cable. Hand tighten the
screws back in place to secure the bracket
12
Cable Security Bracket
Cable Strain Relief bracket
Cable Security Bracket screw
See detailed user guide at www.elotouch.com for additional infomation on mounting
Elo ET0702L as a customer facing display.
Cable Strain Relief bracket
mounting screws (loosen only)
