Elumen8 Beam 5RE User manual

!
!
!
!
Beam 5RE!
!
!
!
!
Order code: ELUM014
!
!
!
!
!
!
!!!!!!!!!!!!!User! Manual!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!Please!read!the!instruction!carefully!before!use!

A
1A
CONTENTS
!
1.!Safety!Instruction!....................................................................................!2!
3.!Technical!Specification!...........................................................................!4!
4.!Fixture!Description!..................................................................................!6!
4.1!Control!Panel!....................................................................................!6!
5.!Gobo!Wheel!and!Lamp!...........................................................................!7!
5.1!Gobo!Wheel!......................................................................................!7!
5.2!Lamp!.................................................................................................!7!
5.3!Change!The!Lamp!.............................................................................!8!
6.!How!to!set!the!fixture!...........................................................................!10!
6.1!Main!Function!.................................................................................!10!
6.2!Home!Position!Adjustment!.............................................................!14!
7.!Control!By!Universal!DMX!Controller!...................................................!16!
7.1!DMX!Connections!...........................................................................!16!
7.2!DMX!Control!...................................................................................!17!
8.!Troubleshooting!....................................................................................!30!
9.!Cleaning!................................................................................................!32!
!

A
2A
!1.!Safety!Instruction! !
!
WARNING! !
Please!keep!this!User!Manual!for!future!consultation.!If!you!sell!the!unit!to!another!user,!be!sure!
that!they!also!receive!this!instruction!manual.!
Important:*
Damages* caused* by* the* disregard* of* this* user* manual* are* not* subject* to* warranty.* The*
dealer*will*not*accept*liability*for*any*resulting*defects*or*problems.!
!Unpack!and!check!carefully!that!there!is!no!transportation!damage!before!using!the!unit.!
!The!unit!is!for!indoor!use!only.!Use!only!in!a!dry!location.!
!Only!to!be!installed!and!operate!by!qualified!persons.!
!Do!not!allow!children!to!operate!the!fixture.!
!Use!a!safety!wire!when!installing!the!unit.!Only!carry!the!unit!by!its!base!and!not!the!head.! !
!The!unit!must!be!installed!in!a!location!with!adequate!ventilation.!
!Make!sure!that!no!ventilation!slots!are!blocked!otherwise!the!unit!will!overheat.!
!Before! operating,! ensure! that! the! voltage! and! frequency! of! the! power! supply! matches! the!
power!requirements!of!the!unit.!
!It’s!important!to!ground!the!yellow/green!conductor!to!earth!in!order!to!avoid!electric!shock.!
!Maximum! ambient! temperature! TA:! 40.! Don’t! operate! it! when! the! temperature! is! higher!
than!this.!
!Do!not!connect!the!fixture!to!dimmer!packs.!
!Make!sure!there!are!no!flammable!materials!close!to!the!fixture!while!operating!as!they!may!
be!a!fire!hazard.!
!Examine!power!cables!carefully;!replace!them!immediately!if!there!is!any!damage.!
!The!fixtures!surface!temperature!may!reach!up!to!85.!Do!not!touch!the!housing!during!its!
operation,! and! allow! 15! minutes! for! cooling! the! unit! down! before! replacing! the! lamp! or!
starting!maintenance.!
!Do!not!operate!in!dirty!or!dusty!environments;!clean!the!fixture!regularly.!
!Do!not!touch!any!power!cables!during!operation!as!there!is!the!risk!of!electric!shock.!
Please!read!the!instruction!manual!carefully!as!it!includes!important!
information!about!installation,!usage!and!maintenance.!

A
3A
!The!minimum!distance!between!light!output!and!the!illuminated!surface!must!be!more!than!
12!meters.!
!Disconnect!the!mains!power!before!fuse/lamp!replacement!or!servicing.!
!Replace!fuse/lamp!only!with!the!same!type.!
!In!the!event!of!a!serious!operating!problem,!stop!using!the!unit!immediately.! !
!The!housing,!lenses!and!the!ultraviolet!filter!must!be!replaced!if!they!are!visibly!damaged.!
!Do!not!open!the!fixture!as!there!are!no!user!serviceable!parts!inside.!
!Never!try!to!repair!the!fixture!by!yourself.!Repairs!carried!out!by!unskilled!people!can!lead!to!
damage!or! malfunction.!Please! contact!the!nearest!authorized!technical! assistance!center! if!
needed.!
!Disconnect!the!mains!power!if!the!fixture!is!not!being!used!for!a!long!time.!
!Always!use!the!original!packing!materials!before!transporting!it!again.!
!To! prevent! or! reduce! the! risk! of! electrical! shock! or! fire,! do! not! expose! the! unit! to! rain! or!
moisture.!
!Hot!lamp!explosion!hazard.!Do!not!open!the!unit!within!15!minutes!after!switching!off.!
!Always!replace!the!lamp!if!it!is!damaged,!deformed!or!life`expired.!
!Do!not!look!directly!at!the!light!while!the!lamp!is!on.!
!Never!touch!lamp!with!bare!fingers.!
!Do!not!operate!the!fixture!without!the!lamp!cover!or!when!the!housing!is!damaged.!
!
Installation:!
1. Bolt!each!clamp!(1)!to!the!Omega!holder!with!the!bolt!and!lock!nut!through!the!hole!in!the!
holder.! !
2. Fasten!the!omega!holders!(2)!on!to!the!bottom!of!the!base!by!inserting!quick`lock!fasteners!(3)!
into!the!holes!of!the!base!and!tighten!fully!clockwise.!
3. Hang!the!fixture!to!the!support!(4)!through!clamp!and!fasten!the!bolts!(5).!Fasten!the!safety!
cable!(6)!through!the!bottom!of!the!base!and!over!the!support.!
4. The!fixture!uses!the!small!Omega!Clamp.!Order!code:!CLAM21!

A
4A
!
!!!
Attention:
!Always!ensure!that!the!structure!to!which!you!are!attaching!the!fixture!is!secure!and!is!able!to!
support!a!weight!of!10!times!of!the!fixtures!weight.! !
!Always!use!a!safety!cable!that!can!hold!12!times!of!the!weight!of!the!fixture!when!installing!.! !
!Make!sure!that!the!fixture!is!firmly!attached!in!way!that!no!vibrating!or!slipping!would!occur!
during!operation.!
!The!equipment!must!be!installed!by!professionals!and!it!must!be!installed!in!an!area!where!it!
is!out!of!the!reach!of!people!and!no!one!can!pass!by!or!under!it.!
!
!3.!Technical!Specification! !
Power!Supply：!
100~240V，50/60Hz! !
Power!Consumption：!
270W!
Lamp：!
Philips!MSD!Platinum!5R! !
Optical!system!
High!quality!optical!system! !
Extremely!powerful!output!
High!quality!lens!
!
!

A
5A
Movement
Pan:!540°! !
Tilt:!270°! ! !
Pan/Tilt!movement!speed!adjustable.!
Automatic!Pan/Tilt!correction!
Easy!calibration!and!maintenance!with!Pan/Tilt!magnetic!home!positioning!
Dimmer/Shutter:!
Mechanical!dimmer!
Mechanical!shutter!and!adjustable!speed!strobe!effect! !
Colour!wheel:!
Colour!wheel:!14!fixed!colours!
Rainbow!effect!in!both!directions!
Easy!calibration!and!maintenance!with!magnetic!home!positioning!
Gobo!wheel:!
Gobo!Wheel:!17!fixed!gobos,!indexable,!
Easy!calibration!and!maintenance!with!magnetic!home!positioning!
Prism:!
8`facet!rotating!prism!Frost! !
Protocols:!
DMX!512!
Data!input/output:!3!Pin!XLR!socket!
Dimension：!
500×394×325mm!
Weight：! !
18kg!
Focus：!
Electronic!
Cooling：!
Fan!Cooling!

A
6A
!4.!Fixture!Description! !
4.1!Control!Panel! !
Front!View Rear!View
1. Microphone：Receives!music!for!sound!active!mode;!
2. LED:!
POWER!
!On!
!Power!On!
DMX!
!On!
! DMX!input!present!
!
3. Button:!
MENU!
To!select!the!programming!functions!
!UP! !
To!go!forward!in!the!selected!functions! !
!DOWN!
To!go!backward!in!the!selected!functions!
ENTER!
To!confirm!the!selected!functions!
4. Function!Display:!Used!to!show!the!various!menus!and!the!selected!functions!
5. DMX!IN:!DMX!512!link,!use!a!3`pin!XLR!cable!to!link!the!unit!and!DMX!controller!
6. DMX!OUT:!DMX!512!operation,!use!a!3`pin!XLR!cable!to!link!to!the!next!unit!
7. Power!Switch:!Turns!the!power!On/Off! !
8. FUSE!(T!6.3A):!Protects!the!unit!from!over!voltage!or!short!circuit!
9. Power!Cable:!Connection!to!the!incoming!power!supply.!

A
7A
5.!Gobo!Wheel!and!Lamp! !
5.1!Gobo!Wheel! !
DANGER!
Only*Install/change*the*gobo>wheel*with*the*fixture*switched*off* *
5.2!Lamp! !
Philips!MSD!Platinum!5R!(8000K)!
!Because!of!its!high!internal!pressure,!there!is!a!risk!that!the!Discharge lamp!can!explode!
during!operation.!The!lamp!emits!intense!UV!radiation!which!is!harmful!to!the!eyes!and!
skin.!The!high!luminance!of!the!arc!can!cause!severe!damage!to!the!retina!if!you!take!a!
close!look!at!the!lamp.!
!To!protect!yourself,!always!turn!off!the!lamp!first!(via!the!control!panel!or!DMX!
controller)!and!let!the!unit!run!for!at!least!five!minutes!to!cool!down!before!switching!
off!the!mains!supply.!Never!handle!the!lamp!or!fixture!when!it!is!hot.!
!Do!not!touch!the!lamp!with!bare!hands.!If!this!occurs,!clean!the!lamp!with!denatured!
alcohol!and!wipe!it!with!a!lint!free!cloth!before!installation!again.!
!The!lamp!generates!UV!radiation.!Never!operate!the!fixture!without!appropriate!shielding.!

A
8A
!When!igniting!the!lamp!operates!at!a!high!pressure!and!there!is!a!slight!risk!of!arc!tube!
rupture.!The!risk!increases!with!age,!temperature!and!improper!handling!of!the!lamp.!Do!
not!use!the!lamp!longer!than!its!maximum!given!lifespan.!
!Make!sure!the!lamp!is!located!in!the!center!of!the!reflector!for!the!best!projection!
!
5.3!Change!The!Lamp! !
Please! replace! the! lamp! after! 2000! Hours,! and! clear! the! lamp! running! time! in! the! menu.!
Disconnect!the!power!cable!before!starting!any!servicing.!
1.!Remove!the!fixture!head!covers!using!a!screwdriver!(Figure!1).!
!
Figure!1!
!
2.!Position!the!head!as!Figure!2!and!remove!the!lamp!cooling!fan!at!the!rear!of!the!head.!
!
Figure!2!

A
9A
3.!Lift!the!lamp!out!of!its!recess!as!Figure!3.!
!
Figure!3!
4.!Disconnect!the!lamp!and!connect!the!replacement!lamp!(Figure!4). Place!the!new!lamp!into!the!
lamp!recess.(Figure!5)!
!!! !
Figure!4!!!!!!!!!!!!!!!!!!!!!Figure!5!
5.! See! illustration! below.! Adjust! the! lamp! using! a! slotted! (flat! head)! screwdriver! until! it! is!
centralized.!
!
Figure!6!