EluneVision Reference Studio 4K Motorized Tab-Tensioned User manual

User Manual for
Reference Studio 4K Fixed
Frame Screens
To the Owner
Thank you for purchasing our Reference 4K line of xed frame screens, using our
excellent screen materials and design, to give you years of trouble free enjoyment.
Please take a moment to read the user manual before installation to avoid any
potential issues.
1. Assembly requires two people and open oor space greater than the size of the
screen
2. Screen material is sensitive to rapid temperature changes, please let material
warm up to room temperature before installation
2. Make sure the workspace is clean and free of debris
3. Keep screen fabric away from high temperatures to avoid permanent material
deformation
Installation Notes
Parts List
Hanging
screw
Material
tensioner
L joiner
screw
L joiner
washer
L joiner
Hanging
bracket
1

1. Philips Screwdriver
2. Level for hanging the screen
Metal Rods,
2 long, 2 short
Screen
Material
Frame Rails, 2 long, 2 short
Tools Required
Installation Procedure
1. Unpack the screen and check that all parts are present
2. Have two people present to assemble and install the screen
3. Assembly requires a clean area of approximately 2 feet of extra space added to
the dimensions of assembled screen on each side
4. Unwrap screen rails, then lay screen rails out, upside down
5. Put the Material tensioners into the frame according to the arrow which marks
their spot (see below)
6. Slide the L bracket into the ends of the two shorter frame pieces
23

7. Connect the short frame with the long frames, as shown below
8. Slide the hanging brackets into place as shown in the picture below
9. Slide all frames together, as shown on the next page. Make sure to place the L
bracket screws with the L bracket washer. The picture does not show the placement
of the washers, but the washers are highly recommended.
10. Unroll the screen material and gently place it on the ground, viewing side down.
Make sure the ground is clear of debris and dirt.
11. Thread the metal rods into each pocket that’s at the corners of the material.
Place the two shorter rods at the shorter side of the screen material and place the
longer rods at the longer side of the screen material.
4 5

67
12. Place the material over the back of the frame and begin to tension the material.
Start at one end of the screen and move along the frame as every material tension-
er is inserted into the proper slot on the side of the material. The last few tensioners
may require hard pulling, this is normal to keep the screen perfectly at.
13. Lift up the screen.
ATTENTION: WHEN LIFTING SCREEN OFF THE FLOOR, USE 2 PEOPLE TO
HOLD BOTH SIDES OF SCREEN AND GENTLY TILT THE SCREEN UPRIGHT.
14. Use a level and mark down the locations to put down the hanging screws. Hang
the screen from the wall at your desired location