Da-Lite Slimline Electrol User manual

INSTRUCTION BOOK FOR
Slimline Electrol®
LIMITED ONE YEAR WARRANTY ON DA-LITE PRESENTATION PRODUCTS
Milestone AV Technologies LLC warrants certain Da-Lite branded products to the original purchaser only, to be
free from defects in materials and workmanship for a period of one (1) year from the date of purchase by the
original purchaser; provided they are properly operated according to Da-Lite's instructions and are not
damaged due to improper handling or treatment after shipment from the factory.
This warranty does not apply to equipment showing evidence of misuse, abuse or accidental damage, or
which has been tampered with or repaired by a person other than authorized Da-Lite personnel.
Da-Lite’s sole obligation under this warranty shall be to repair or to replace (at Da-Lite’s option) the defective
part of the merchandise. Returns for service should be made to your Da-Lite dealer. If it is necessary for the
dealer to return the screen or part to Da-Lite, transportation expenses to and from Da-Lite are payable by the
purchaser and Da-Lite is not responsible for damage in shipment.
To protect yourself against damage or loss in transit, insure the product and prepay all transportation
expenses.
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY IS IN LIEU OF ALL OTHER
WARRANTIES, EXPRESS OR IMPLIED, INCLUDING WARRANTIES AS TO FITNESS FOR USE AND
MERCHANTABILITY. Any implied warranties of itness for use, or merchantability, that may be mandated by
statute or rule of law are limited to the one (1) year warranty period. This warranty gives you speciic legal
rights, and you may also have other rights, which vary from state-to-state. TO THE MAXIMUM EXTENT
PERMITTED BY APPLICABLE LAW, NO LIABILITY IS ASSUMED FOR EXPENSES OR DAMAGES RESULTING
FROM INTERRUPTION IN OPERATION OF EQUIPMENT, OR FOR INCIDENTAL, DIRECT, OR
CONSEQUENTIAL DAMAGES OF ANY NATURE.
In the event that there is a defect in materials or workmanship of a Da-Lite product, you may contact our Sales
Partners at PO Box 137, Warsaw, IN 465810137, (574) 2678101, (800) 6223737.
IMPORTANT: THIS WARRANTY SHALL NOT BE VALID AND DA-LITE BRANDED PRODUCTS SHALL NOT BE
BOUND BY THIS WARRANTY IF THE PRODUCT IS NOT OPERATED IN ACCORDANCE WITH THE DA-LITE
WRITTEN INSTRUCTIONS.
Keep your sales receipt to prove the date of purchase and your original ownership.
72641
A Milestone AV Technologies Brand
3100 North Detroit Street
Warsaw, Indiana 46582
P: 574.267.8101 or 800.622.3737
F: 574.267.7804 or 877.325.4832
E: [email protected]
www.da-lite.com
DL–0261 (Rev. 2) 10.14
© 2014 Milestone AV Technologies LLC. Printed in U.S.A.

Important Safety
Instructions
Suggested Methods Of
Installation
Care Of Screens
Accessories
Operating Instructions
When using your video equipment, basic
safety precautions should always be
followed, including the following:
1. Read and understand all instructions
before using.
2. Position the cord so that it will not be
tripped over, pulled, or contact hot
surfaces.
3. If an extension cord is necessary, a
cord with a current rating at least
equal to that of the appliance should
be used. Cords rated for less
amperage than the appliance may
overheat.
4. To reduce the risk of electric shock,
do not disassemble this appliance.
Contact an authorized service dealer
when repair work is required.
Incorrect reassembly can cause
electric shock when the appliance is
used subsequently.
5. The use of an accessory attachment
not recommended by the
manufacturer may cause a risk of ire,
electric shock, or injury to persons.
Save These Instructions
To Lower Screen Surface
Press lower end of slide switch.
Screen will stop in the “DOWN”
position automatically.
To Raise Screen Surface
Press upper end of slide switch.
Screen will stop in the “UP” position
automatically.
To Stop Screen
Screen may be stopped in any
intermediate position by positioning
slide switch to center “OFF” position.
NOTE: It is suggested that when
screen is not in use, the slide switch
should be positioned to center “OFF”
position.
1. Examine surface to be sure it is free of insects, dirt or foreign matter before
rolling into case.
2. Screen may be operated as frequently as necessary but should not be run up
and down continuously. To do so will cause the motor to overheat and the
thermal overload to cut out. Should this occur, it will be necessary to wait for
the motor to cool suiciently to resume operation.
3. Motor does not require lubrication.
Picture
Surface
Picture
Surface
Picture
Surface
Picture
Surface
Wall Bracket
Use No. 6
brackets to
hang from
beam or
valance
Ceiling
Mounting
Place “D” rings
over hooks well
secured in ceiling.
Wall Mounting
Slip hanger
eyes over
screws well
secured in wall.
Concealed
Allow room for access
No. 6 Wall Bracket
Non-adjustable permits screen
to extend 6" from wall.
No. 11 Wall Bracket
Non-adjustable permits screen
to extend 10" or 14" from wall.
3Position Switch
3Position Switch
Complete with cable,
is standard with the
Slimline Electrol.