
USB Adapter Charging Speed
Adapter Current Output Charging Time
5V/2.1A about 5 hours
5V/1.5A 6 - 7 hours
5V/1A 10 - 11 hours
5V/0.5A about 24 hours
Vehicle Instruction
1. Make sure that the number of indicators is not less than 3 ones
2. Connect the RED clamp to the vehicle‘s battery positive (+) terminal and connect the BLACK clamp to the
vehicle‘s battery negative (-) terminal.
3. Plug the cord of jumper cable into the jump start socket.
4. Check indicator light on clamps , Green light means ready to go , then start the vehicle
(otherwise please check the connection).
Warning:
At extremely low volt of your batterie, it may happen that the display of the LED does
not turn green. Then please check the bottom of the black electronic box. Press
with a paper clip the „boost button“.
5. When the vehicle is started, remove the jumper cable from this gadget and
disconnect RED and BLACK clamps to vehicle battery.
6. Leave the vehicle‘s engine running.
Usage Notes & Warning:
• The quick-starter to start vehicles with engine capacity up to 4 liters.
• This is possible even without a car battery or battery completely defective.
• Always make sure the blue plug of cable connect with the jump start socket tight in this product before jumping
start the vehicle. Otherwise, it will affect the results, even causing the melt of the blue plug.
• Always check if the jumper clamps are well connected.
• DO NOT jump start again after 3 attempts. Otherwise, it will damage the host.
Check your vehicle if has other trouble.
• Please keep this gadget about 30 feet away from your vehicle when using the compass
Warning!
• Do not modify or disassemble this product.
• Always take care when using this product.
• Do not use as a toy.
• Do not allow this product to become wet. Do not immerse this product in water .
• Do not store in locations where the temperature may exceed 70°C. The advised storage temperature
is -10°C℃ to 45°C. Under extreme conditions, battery leakage may occur.
• Do not operate this product in explosive atmospheres, such as in the presence of flammable liquids,
gases or dust.
Warranty
Our company provides customers with a warranty of 12 months from the date of the purchase. We may not cover
the damage caused by misusing the product.
Charging Cell Phone or Tablet Instruction
1. Plug the switch cable to USB 5V/2.1A output port. (moro)
2. Select appropriate connector for your cell phone or tablet and
connect it to any of them , this gadget can identify and charge the
electronic automatically . The indicators will be on when the device
is charging
3. The LED lamps are lit during the charging process.
How long will the power of battery of this
gadget remain?
6-12 months, however, we suggest you recharge it
every other 3 months.
How many times can this gadget on a full
charge to start the vehicle?
Approx. 20 times.
LED-Lampe mit SOS-Funktion
1. Press the switch 3 seconds to turn on/off the LED flash light.
2. There are 3 modes of LED light: Normal light, Strobe, SOS, which can be shift in turns
by pressing the switch .
3. Press the switch 3 seconds to turn off the LED flash light no matter you are in any mode.
Distribution: ELYSEE GmbH · Heerdter Lohweg 212 · 40549 Düsseldorf · mail@oldtimer.tools · Tel. +49 (0) 211-522 894-0
pointed
Object
Boost-
button