Emagra FLAP User manual

STEP 1
1. Take the seat out of the box
2. Take the backrest out of the box
3. Remove headrest, gaslift, base, casters, screws (3,4,5,6)
STEP 3
1. Insert 5pcs of casters
into the base, then insert
gaslift into the opening
in the base
2. Put the plastic cover
on the gaslift
3. Insert the gaslift into
the corresponding hole
in the mechanism
4. Click the plastic cover
into the seat
STEP 2
1. Fasten backrest to
the mechanism
2. Tighten the screws
A- 4 pcs
User guide
Maintenance and attention
1. The chair can only be used by one
person at a time.
2. Do not use the chair as a stool or
ladder.
3.Do not use the chair unless all parts are
properly assembled.
4.Do not use the chair untill all screws are
properly tightened.
5. If the chair is damaged by external
influences, do not use it without expert
repair.
6. For professional servis, please contact
us by phone [phone], or by mail
[email protected]
6. Screws
Model Flap
A
M8x14
4 pcs
Backrest
1 pcs
IMBUS
Assembly instructions –model FLAP
www.emagra.cz/cs/m-388-kancelarska-zidle-flap-b
Used parts
(Note: Some parts may be different than images)
1.
Backrest
2. Seat+mechanism+armrests
3.
Gaslift with
cover
4. Base
5.
Casters

Using instructions - model FLAP/B/W
www.emagra.cz
Two levers, serving as a separately
height-adjustable lumbar spine support
Armrest is height adjustable
Lever used for height adjustment of the chair.
Push the lever forward to activate the gaslift.
Please lighten the seat when moving up.
Lever used to lock the backrest position.
Push the lever forward to release the
backrest. Push the lever back in the
working position to block the backrest.
Detail of the seat