EMIT EKP2 User manual

Users manual
EKP2
Biathlon
(c) Emit 13.april 2004, rev 1
Emit AS Tel: [phone]
Bedriftsvn. 10 WEB: www.emit.no
N 0950 OSLO E mail: [email protected]

EKP2 Biathlon is an easy-to-use keypad made for entering start numbers and
shooting misses in biathlon, or just start numbers in cross-country events. he
EKP2 connects with the RAC-box, which again connects with R R2/PC.
Keys that are in use:
Clear/ON - turns the unit on/off and deletes si ns
Enter ( ) - accepts entered value
Numerical keys and comma
Usage of EKP2 Biathlon:
Connect the EKP2 to the RAC-box by usin the phone connector to the far left.
Turn on the unit by pressin and holdin down the Clear/ON key.
The upper display shows the software version and battery level to the ri ht. The
lower display shows the serial number.
Choose ri ht address for the EKP2 and accept entered value with . If only usin
one EKP2 one should enter "1" as the address. If usin more than one EKP2 the
addresses used should correspond with the number of keypads used. All EKP2s
must have a unique address.
Choose between ski jumpin and biathlon. The upper display shows "JU1" and
the lower display shows "bI2". This means that one should press "1" for ski
jumpin and "2" for biathlon or cross-country. Press "2" and accept with .
The EKP2 is now ready for use.
Enter the start number and the number of misses separated by comma, and accept
by pressin . If usin the EKP2 for enterin start numbers only, enter the start
number and accept by pressin . The EKP2 sends the data to RTR2/PC, and is
ready to accept new input as soon as RTR2/PC has received the data.
Turn off the EKP2 by pressin and holdin down the Clear/ON key for about
three seconds.
The battery used in the EKP2 is soldered on and should only be replaced by
authorized personnel. With normal usage it will last for many years.
Copyright 200 Emit.as 13.0 .200