Emmlight EVO Freestanding User manual

Installation instruction
1 3
4 5 6
7 8 9
10 11 12
12
3
Product list: lamp body base plate
1 2
pole
3power cord
4
accessories bag
5
2
Fix the bottom pole onto base plate
Insert the lamp holder into
the other end of the pole
Lamp holder xed ready by step6,7,8
Fix the lamp holder with screws-1
Fix the lamp holder with screws-2 Fix the lamp holder with screws-3
45
Connect the terminal block
Insert the power cord
Fix the PIR sensor into the holder Close the box by screws
Open the box of lamp body

1. Short press to turn on/off.
2. Long press to dimming.
Infrared Sensor
Wirie
PIR sensor
DIP switch
Screw cap
This product is an energy automatic sensor switch,it can identify day and night. It adopts infrared
detector, IC and SMD technology, when someone enter its detecting range and triggered it work, the
infrared detector turn on the lamp, after he leave its range, the lamp will turn off automatically. It can
detect the ambient light illumination automatically and set and adjust the value according to the fact
need. Such as, the light will turn on and works when the ambient light illumination is under setting
value. once it exceeds the setting value, the light will stop working. It can be installed in indoor,
corridor and public-building.
Correct moving orientation Detection angle
100°8m (22°C)
Sensor information
Function
1.Adopts 8-bit DIP switch:
·You can select working light to work only in the light
below 10lux or in any light;
·Adjustable sensitivity;
·Choose working time-delay of the load: 5s, 30s,
1Min,3Min, 5Min, 8Min.
2.The time that the load work can delay automatically:
it re-computes time after the last sensing;
3.Out connect infrared detector and sensitization
resistor;
4.Simple structure and using convenient.
Summary