manuals.online logo
Brands
  1. Home
  2. •
  3. Brands
  4. •
  5. EMS
  6. •
  7. Cell Phone
  8. •
  9. EMS FireCell FC-555-001 User manual

EMS FireCell FC-555-001 User manual

RESET
LOGON
BACK
HEALTHY
FAU LT
SYS FAULT
RF1 RF2
EN54-4 UNIVERSAL PSU
FC-60-1000
INPUT: 220-240VAC, 50Hz, 0.3A
OUTPUT: 5.0-8.5VDC, 0.8A MAX
STATUS
FAULT
MAINS / CHARGER FAIL
BATTERY LOW
BATTERY FAIL
START
INPUT
L N E
For additional information refer to TSD042
0359-CPR-00267
15
0905
RESET
LOGONBACK
HEALTHY
FA U LT
SYS FAULT
RF1 RF2
EN54-4 UNIVERSAL PSU
FC-60-1000
INPUT: 220-240VAC, 50Hz, 0.3A
OUTPUT: 5.0-8.5VDC, 0.8A MAX
STATUS
FAULT
MAINS / CHARGER FAIL
BATTERY LOW
BATTERY FAIL
START
INPUT
L N E
For additional information refer to TSD042
0359-CPR-00267
15
0905
UNIVERSALPSU EMS-PSU-002
INPUT:220-240VAC, 0.3A
OUTPUT:5.0-8.5VDC, 1.0A MAX
STATUS
FAULT
MAINS/ CHARGER FAIL
BATTERYLOW
BATTERYFAIL
START
INPUT
L N E
14
Foradditional information refer to
InstallationInstructions
0359-CPR-XXXX
0359
230 VAC Radio Cluster Communicator (RCC)
Installation Guide
FC-555-001
FC-555-331
230 VAC RCC c/w PSU
230 VAC RCC c/w remote aerial facility & PSU
RADIO CLUSTER COMMUNICATOR
POWER
FA ULT
1 Pre installation
!
Installation must conform to applicable local installation
codes and
should only be installed by a fully trained
competent person.
Ensure the RCC is installed as per the site survey.
Refer to step 3 to ensure optimised wireless performance.
If using remote aerials with this product, refer to the remote
aerial installation guide for more information.
This device contains electronics that may be susceptible to
damage from Electrostatic Discharge (ESD). Take appropriate
precautions when handling electronic boards.
2 Components
Radio Cluster Communicator
POWER
FAU LT
1236
4
4x corner covers 4x lid screws 1x RCC lid
1x RCC PCB 1x RCC back box
3 Mounting location guidelines
POWER
FAULT
0.6 m
2 m
RCC
The RCC must not be installed
within 0.6 m of any metal
work.
4 Optional PCB / PSU removal
Remove the three circled retaining screws, prior to unclipping
the PCB.
If removing or rotating the PSU for right hand side mains
entry, remove both PSU retaining screws.
5 Remove cable entry points
Drill the cable entry
points as necessary.
= DO NOT use
= Available cable
entry points
All five circled
fixing positions
are available for
use.
The key hole can
also be used for
locating and
fixing where
required.
6 Fix to the wall
5
1x RCC PSU
Part no Product description
12 3
456
For optimum wireless
performance,the
following must be
observed:
Ensure the RCC is not installed
within 2 m of other wireless or
electrical equipment.
©2021 EMS Ltd. All rights reserved Page 1 of 2 TSD053-99 Iss 26 15/12/2021 AJM
Earth wire
Neutral wire
Live wire
RESET
LOGON
BACK
HEALTHY
FAU LT
SYS FAULT
RF1 RF2
HEALTHY
FA U LT
SYS FAULT
Operating
temperature -10 to +55 °C
Storage
temperature 5 to 30 °C
Humidity 0 to 95% non-condensing
IP rating IP54
Battery backup 1 x 6V 4Ah Yuasa NP4-6 (sold separately)
For information on routine battery changes, refer to the Universal PSU
instructions (TSD042)
Power requirements Mains powered 220 to 240 VAC, 50 Hz
Current consumption 44 mA (normal operation)
55.5 mA (with mains disconnected)
Battery standby time 72 hours*
*Typical 5 year battery life based on normal usage.
Note; if 72 hours battery standby is required, it is recommended that the
battery is replaced every 3 years.
Operating frequency 868 MHz
Output transmitter
power Auto adjusting 0 to 14 dBm (0 to 25 mW)
Dimensions (W x H x D) 270 x 205 x 75 mm
Weight 1.9 kg (including battery)
1.15 kg (excluding battery)
Location Type A: For indoor use
2012/19/EU (WEEE directive):
Products marked with this symbol cannot be
disposed of as unsorted municipal waste in the
European Union. For proper recycling, return this
product to your local supplier upon purchase of
equivalent new equipment, or dispose of it at
designated collection points. For more information
see www.recyclethis.info
Dispose of your batteries in an environmentally
friendly manner according to your local regulations.
European Union
directives
EMS declares that this device is in compliance with
Directive 2014/53/EU. The full text of the EU
declaration of conformity is available at the following
internet address: www.emsgroup.co.uk
Approved to EN54-4:1998 Incorporating Amendments Nos. 1 and
2. Fire detection and fire alarm systems.
Part 4: Power supply equipment.
EN54-18:2005. Fire detection and fire alarm
systems. Part 18: Input/output devices.
EN54-25:2008. Incorporating corrigenda September
2010 and March 2012. Fire detection and fire alarm
systems. Part 25: Components using radio links.
Certification
Certification body
CPR DoP 0359-CPR-0046
9 Configuration
The RCC’s programming and loop address are configured within
the menu structure of the radio hub.
8 Applying power
Connect the 6V 4Ah battery (sold separately) and apply power to
the RCC. The normal LED states for the RCC are as below:
10 Close RCC
Healthy LED - green LED will be on.
Fault LED - yellow LED will be off.
Sys fault LED - yellow LED will be off.
The RCC is powered from a 220 to 240 VAC supply and requires
a 5 A protection device.
Power cables should only be passed via the access points
available.
Flame retardant cable glands must be used.
DO NOT leave excess cable in the RCC.
Cable should have a minimum cross section of 1.5 mm2
An all-pole mains switch should be provided as part of the
building installation.
RADIO CLUSTER COMMUNICATOR
POWER
FAU LT
Refer to the programming manual (MK98) for full programming
information.
Free to download from
www.emsgroup.co.uk
0905
10
Ensure that the RCC PCB is correctly inserted and the PCB
retaining screws are refitted.
Refit the RCC lid, ensuring LEDs are not damaged by the light
pipe when refitting.
Manufacturer Carrier Manufacturing Polska Sp. Z o.o. Ul.
Kolejowa 24. 39-100 Ropczyce, Poland
Year of
manufacture See devices serial number label
Regulatory informationSpecification
EN54-4 UNIVERSAL PSU
FC-60-1000
INPUT: 220-240VAC, 50Hz, 0.3A
OUTPUT: 5.0-8.5VDC, 0.8A MAX
STATUS
FAULT
MAINS / CHARGER FAIL
BATTERY LOW
BATTERY FAIL
START
INPUT
L N E
For additional information refer to TSD042
0359-CPR-00267
15 0905
7 Connection wiring
©2021 EMS Ltd. All rights reserved Page 2 of 2 TSD053-99 Iss 26 15/12/2021 AJM

This manual suits for next models

1

Other EMS Cell Phone manuals

EMS fireCell FC-TAK-438-001 User manual

EMS

EMS fireCell FC-TAK-438-001 User manual

EMS FireCell FCX-438-001 User manual

EMS

EMS FireCell FCX-438-001 User manual

EMS FireCell FC-555-024 User manual

EMS

EMS FireCell FC-555-024 User manual

EMS FIRECELL Owner's manual

EMS

EMS FIRECELL Owner's manual

EMS FireCell FC-555-331 User manual

EMS

EMS FireCell FC-555-331 User manual

Popular Cell Phone manuals by other brands

Nokia X2-00 user manual

Nokia

Nokia X2-00 user manual

Haier D1000 user guide

Haier

Haier D1000 user guide

SIMTOO ST308 user manual

SIMTOO

SIMTOO ST308 user manual

Nokia Lumia 830 user guide

Nokia

Nokia Lumia 830 user guide

Allview A20 Max user manual

Allview

Allview A20 Max user manual

Samsung GT-N5120 user manual

Samsung

Samsung GT-N5120 user manual

NEC N500i user guide

NEC

NEC N500i user guide

LG Optimus F7 user guide

LG

LG Optimus F7 user guide

Kyocera 7135 - Smartphone - CDMA2000 1X user guide

Kyocera

Kyocera 7135 - Smartphone - CDMA2000 1X user guide

Alcatel OT-565 user guide

Alcatel

Alcatel OT-565 user guide

Zte Blade A72 quick start guide

Zte

Zte Blade A72 quick start guide

Oppo Realme user guide

Oppo

Oppo Realme user guide

Aquos xx3 mini user guide

Aquos

Aquos xx3 mini user guide

HTC Typhoon Service manual

HTC

HTC Typhoon Service manual

LG Aristo LG-MS210 user guide

LG

LG Aristo LG-MS210 user guide

Mobo URBAN user manual

Mobo

Mobo URBAN user manual

LG LW690 owner's manual

LG

LG LW690 owner's manual

LG GD900 Titanium -  GD900 Crystal Cell Phone 1.5... user guide

LG

LG GD900 Titanium - GD900 Crystal Cell Phone 1.5... user guide

manuals.online logo
manuals.online logoBrands
  • About & Mission
  • Contact us
  • Privacy Policy
  • Terms and Conditions

Copyright 2025 Manuals.Online. All Rights Reserved.