encompass HB-035 User manual

HB-035
Archer’s Den Hunting Ground Blind
Instruction Manual
ENCOMPASSINTL.COM

Please inspect the shipping carton for damage or
evidence that it may have been opened before you
received it. Then inspect your hunting blind carefully.
Compare it to the picture on the product label and
the picture illustration in your instructions. If for any
reason you are not satised with the product, do not
use it until the problem is corrected.
THIS BLIND IS NOT FIREPROOF. KEEP AWAY FROM ALL SOURCES OF OPEN FLAME OR HIGH HEAT. THE FLAME RESISTANT FABRIC
MEETS THE REQUIREMENTS OF CPAI-84 BUT IT WILL BURN IF LEFT IN CONTACT WITH OPEN FLAME OR EXTREME HEAT. THE
APPLICATION OF ANY FOREIGN SUBSTANCE TO THE FABRIC MAY RENDER THE FLAME RESISTANT PROPERTIES INEFFECTIVE.
WARNING
GENERAL GUIDELINES FOR YOUR BLIND
Avoid leaving blind outdoors for any extended period of time. Prolonged exposure to sunlight may cause fabric to fade.
Never allow children to play with this product without adult supervision.
Never allow material to cover your face. It can cause suffocation, death.
Never allow anyone to use lighted candles, matches or other sources of re near this product.
Never use a heater in this blind. Fumes could cause sickness or death.
Keep these instructions for future reference.
For your safety, be sure to read all instructions and warnings carefully.
Instruction and Safety Manual
(HB-035)
Package Contents
qPart # HB-035 - Hunting Blind
qPart # 1324 - Carrying Case
qPart # 1301 - Ground Stakes (16) w/ bag
qPart # 1302 - Tie Down Cords (4)
qPart # 1325 - Fiberglass Poles (2) w/ bag
qPart # SK-035 - Shoot-thru Screens (8)
Care instructions:
Spot clean with mild soap and water. Ensure blind is dry before transporting or storing to prevent mildew and damage.
Store in cool, dry place out of direct sunlight.
Encompass International Peoria, IL 61615
encompassintl.com © 2023 Encompass International

WARNING
• The construction of this hunting blind uses spring steel and will open quickly. Always hold hunting blind
away from your body during set-up.
1 2 3
Tie a tie down cord to each
of the tie down cord loops
on the sides of your blind.
Each tie down cord will be
staked out to each side of
the blind. (P1)
Pull the tie down cords tight.
(P2)
Use the plastic slides and
cinch the cords until the
blind is secure. (P3)
1 2 3 4
5
Remove your hunting blind
from its carrying case
by holding all three rings
together.
Carefully open the blind
while holding two of the
rings.
The blind will spring out
and open for separating
sections.
Separate the walls of the
blind by unfolding into two
walls.
Then separate the remaining
walls to form all four walls.
6
Extend the poles to full
length and insert into the
wall pockets on the inside of
the blind. The poles should
form an X in the center of
roof. Tie poles together us-
ing cloth strings.
SET-UP
TIE DOWN CORDS

7
Fold the blind towards your
feet until top of blind is
touching your feet.
8
Fold the loop in your left
hand down.
WARNING
• Remove all ground stakes, tie down cords, and roof support poles before attempting to fold up blind.
1 2 3 4
5
Standing in the center of
walls, facing the blind, pull
the opposite side centers of
the two walls toward you.
Fold sides together. Your blind should be in this
position. Place hands at 10
and 2 o’clock at top of blind.
Fold the blind towards the
ground till you are about 2
feet from the ground.
Move your hands down
about 6 inches and pull both
sides togther.
6
Rest the blind between your
knees, then rotate your
hands so your
knuckles are facing in.
TEAR DOWN
9
Fold the loop in your right
hand down.
10
Even the loops and stow
away.