Tools Required: Rubber Mallet or Hammer
1. 2. 3.
4.
Instructions
1Fix the four corners of the Base Tent to the ground using the metal
pegs.
Item Component Name Qty Part No.
1Carry Bag 1-
2Guy Rope 8C910
3Metal Peg 2C909
4Telescopic Support Pole 4-
5Instructions 1R662
Telescopic Support Pole 431106
Rhino-Rack Sunseeker II Base Tent Stand Alone Fitment (32124)
Hammer the
pegs rmly into
the ground.
2Insert the Upper Support Poles into
the material tubes on the roof of the
tent. Note: Support Poles included in
Base Tent Kit.
3
1: Slide the Base Tent roof
supports through the
material tubes. Use care
when doing so as to not
damage the tent.
2: Slide the Base Tent roof
supports into the plastic
housings on each corner of
the roof.
Insert the Telescopic Poles into the
ring xture points on the front side of
the tent.
3 Pike Street, Rydalmere,
NSW 2116, Australia. Document No: R662
(Ph) (02) 9638 4744 Prepared By: Kayle Everett Issue No: 01
(Fax) (02) 9638 4822 Authorised By: Chris Murty Issue Date: 27/01/2015
Pole spike
into this
eyelet.
