Energenie is a trading name of Sandal plc, Claremont House, Deans Court, Bicester, UK, OX26 6BW
If you have questions, please visit us at www.energenie4u.co.uk
• Radio controlled Socket with controller for use with domestic appliances
• Conveniently switch o appliances to reduce Standby usage and save money
•The remote control does not require direct line-of-sight to operate. It can work even when
the socket is hidden behind furniture or in an adjacent room
• 4 channel remote control plus all On/O buttons
• Dual controller option, a socket can now be controlled by two remote controllers
• 13 Amp rated sockets to BS5733, indoor use only
Radio Controlled Sockets
d
u
a
l
c
o
n
t
r
o
l
l
e
r
o
p
t
i
o
n
160112
General:
Radio Frequency: 433.92Mhz
Range: Ca. 25 metres in open area
Remote controller:
4 separate channels + all ON/OFF
Battery: replaceable 3V CR2032
Transmission indicator lamp: red=ON
Data protocol: simplex one way
Product Code: ENER002-C
Socket:
Rating: 220-250V~ 50Hz, 13A, 3kW max.
Power consumption in standby: < 0.3W
Socket LED: red = ON, o = OFF
Socket button:
• Single press to toggle power ON/OFF
• Long press for 6 seconds: learning
• Long press > 6 seconds: factory reset
Applications: Domestic appliances with
a standard UK plug. Indoor use only
Dual Controller Option
The socket can be controlled by two
remote controllers. Additional remote
controllers can be purchased through
our website.
When an attempt is made to link a third
controller with a socket, it will automati-
controller.
Setting up - Learning remote controller key codes
1. Remove the battery protective tag from the hand control
ler - the battery is pre-installed.
2. The socket can learn the up to 2 separate hand control-
lers using the following procedure:
Insert the plug into a powered mains wall socket. The red
indicator light near the ON/OFF button should ash at 1
second intervals indicating it is ready to learn a key code
from the hand controller.
If the light is not ashing, ensure the sockets is o, then
press and hold the green button on the front of the socket
for 6 seconds or so until it starts to ash at 1 second inter-
vals.
3. Point the hand controller at the socket and press and
hold briey the ON button for one of the pairs of numbered
buttons you wish to use to control the socket. The RED
indicator light on the housing will ash quickly then turn
o indicating the socket was successfully programmed.
Using the hand controller to switch the sockets
• Plug in your appliance then use the numbered button
pair you have selected to switch the required socket ON or
OFF.
• Use the ALL button pair to switch all sockets paired with
this controller ON or OFF at the same time.
Using the green button on the housing to switch the
sockets
• Press the green button on the housing to toggle the
socket ON/OFF during normal operation.
Add a new hand controller
The socket can remember upto 2 hand controllers. Put the
socket into learning mode again as indicated in the
Setting-up procedure and follow the same procedure for
the new hand controller.
Factory Reset
The device memory can be fully erased by a factory reset:
1. Turn the socket OFF
2. Press and hold the Green button on the socket until the
RED LED lamp ashes at 1 second intervals. Keep pressing
the button until you see it brey ash more quickly indicat-
ing full reset has occurred.
