Energotech RC7 User manual
User Guide
Product code: RC7 Date: 16.09.26-01EN
Energotech AB | Box 8053 | SE-200 41 Malmö, Sweden
MANUAL MULTI-TRANSMITTER
DESCRIPTION OF THE PRODUCT
UHF band transmitter with PPL controlled carrier frequency.
This type of transmitter is used for controlling devices for
domestic use, automatic openings, ON-OFF light control,
dimming, etc. This appliance transmits a rolling code type
signal to guarantee maximum secrecy. The transmitter code
can be stored in the receiver directly via the latter or via radio
from the transmitter. With the second possibility you can add
new transmitters to an existing system without having to
touch the receiver. This can be done directly by the end user
(the installer’s help is not required). The code is stored in the
receiver’s EEPROM memory that retains it even if power is
cut temporarily.
SAFETY RULES
• Keep this manual transmitter out of the reach of children
and animals.
• Do not use the manual transmitter in places or where systems
are sensitive to radio emissions (e.g. airports, hospitals).
• Do not keep or use the manual transmitter in places that
are damp, where there is steam, high air humidity, dust or
where it is exposed to the direct rays of the sun or similar
environmental conditions.
• Do not let the manual transmitter drop: it could be damaged
or its range of action reduced.
USE
The operator is in no way protected against interference from
other telecommunication equipment or systems (e.g. authorised
radio systems working on the same frequency range). If you
are having problems with its range of action, x the manual
transmitter up high. Change the battery if necessary.
CHANGING THE BATTERY
• Keep the batteries out of the reach of children. Call a doctor
immediately if a battery is swallowed.
• Explosion hazard if the battery is substituted incorrectly.
• Replace the battery with a CR2430 type battery only.
• Always wrap the battery up, both when it is being stored and
when it is being disposed of. The battery should not come into
contact with other metal objects as it could cause the battery
to run down, catch re or be damaged.
• Dispose of damaged or nished batteries immediately in
compliance with the law. To this end, contact the
authorities for safeguarding the environment or the
centre for disposing of waste materials in your area.
Do not throw the battery away with household rubbish.
1 - Remove the screw on the back.
2 - Slide each other the two cases and open.
3 - Take the old batteries out and put the new ones in the same
way. Pay attention to correct polarity (+/-)!
4 - Close the transmitter with the screw.
GUARANTEE
The guarantee complies with the law. If the guarantee has
to be used please refer to the specialized retailer. The right
to the guarantee is applicable only for the country in which
the manual transmitter was purchased. The batteries are not
covered by the guarantee.
HOW TO STORE A TRANSMITTER VIA RADIO WITHOUT
ACCESSING THE RECEIVER BY MEANS OF A
PREVIOUSLY STORED TRANSMITTER
- Press the internal key P3 of a previously stored transmitter,
the enabled receiver emits a continuous sound for 5 seconds.
- Transmit a channel present in the memory of the receiver, in
which the new code is to be memorized, within 5 seconds and
the buzzer will interrupt the sound for 1 sec, and then carry
on for another 5 seconds.
- Transmit the new channel to store within 5 seconds,
conrmed by intermittent buzzing.
TECHNICAL DATA
The transmitters are coded directly by the manufacturer with
a different code for each transmitter.
TECHNICAL SPECIFICATIONS
Carrier frequency 868.3 MHz
Power supply 3V ± 10%
(lithium battery CR2430)
Consumption when transmitting 10 mA
Working temperature -10° +55°C
In the view of a constant development of their products, the
manufacturer reserves the right for changing technical data
and features without prior notice.
EN
Single button
commands for
receiver ON-OFF
Note! CH5 has a
double button
command
TRANSMITTER / REMOTE CONTROL - RC7
Double button
commands for
receiver ON-OFF
Commands and
pre-set levels
for receiver DM20
CH1
CH2
CH3
CH4
CH5
CH6
CH7
On/
Off
On/
Off
On/Off
On/
Off
CH1
CH2
CH3
CH4
CH5
CH6
CH7
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
On/Off
CH1
CH2
CH3
CH4
CH5
CH6
CH7
100%
66%
50%
OFF
Not in use
Not in use
Not in use
P3
C
R
2
4
3
0
Dimmer commands
and pre-set levels
for receiver DM65
CH1
CH2
CH3
CH4
CH5
CH6
CH7
100%
75%
50%
Min
Dim +
Dim -
According to section 2.1 in the installation guide, for the On-Off receiver
According to section 2.2 in the installation guide, for the On-Off receiver
1234
OFF
***
*
**
