ENERMAX EMK3102 User manual

User manual
EMK3102
Attention
Basic Usage
Pull the spring lock to open the front door.
Place the HDD into EMK3102 with its printed label up-sided.
Press the door to push the hard drive into EMK3102 until the door is locked.
1.
3.
2.
4.
1. To perform hot-swap function, the host must also support hot-swap.
2. Keep the device out of high temperature and humid environment.
3. If the device or HDD is damaged due to improper operation, we would not take the
responsibility of compensation or repair.
Attach the included mylar film as shown.
1. Smoothly pull the spring lock to open the door. Make sure the key lock
is on a removable position, or the lock would get damaged.
2. Carefully take the hard drive out from EMK3102.
Unload the Hard drive

Package content Parts
Screw the EMK3102 with 2 screws of each side to securely hold the device.
Installation
Remove the cover of an empty drive bay.
Insert EMK3102 into the bay and align the screw holes.
1.
3.
2.
Lock
Unock
Accessories Quantity
EMK3102 1
SATA 7 pin data cable 1
SATA 15 pin to 4 + 4 pin Power Cable 4 1
Screws 4
Key 1
IInsulating pad 1
User manual 1
Front panel
1. Key lock (A:Lock B:Unock)
2. Easy latch door
3. HDD LED indicator
Back panel
1. SATA power connector (15P)
2. SATA data connector (7P)
3. LED access port (4P)