ENERMAX UC-S106 User manual

0
UC-S106
Mobile Rack
User’s Manual
SATA to SATA

1
Index
Package content Page 1
Product illustration Page 2
Feature & Specification Page 3
Installation Page 4
Caution Page 5
Package content:
1. Mobile rack *1
2. User’s Manual *1
3. Accessory kit:
a. Security key *1
b. Screws for HDD *4 (#6-32UNC)
c. Screws for mobile rack *4 (M3 * 0.5)
#6-32UNC M3 * 0.5

2
Product illustration

3
Feature:
1. Support 3.5” SATA HDD
2. Data transfer rate is up to 150 MB/sec
3. Plug & play with hot-swap ready
4. Aluminum design for the best effective heat dissipation
5. Built-in a patent blower in the bottom offering the extra solution
of heat dissipation
6. Unique easy in / out handle design for the inner tray
7. “Key Lock” design to secure your HDD
Specification
Application 3.5” SATA HDD
Material Aluminum /ABS
Interface SATA to SATA
Data transfer rate 150 MB/sec
DC input 4-pin power connector
LED indicator 2 (Power & HDD)
Cooling fan 6 cm blower *1 (bottom)
Product dimensions (D*W*H) 224*148*42 mm

4
Installation
1.Turn off the key lock and take
out inner box.
2. Open the upper cover and
connect the SATA power pin
header with SATA HDD.
3.Fix the HDD with screws
(#6-32UNC), then close upper
cover.
4.Secure the frame by using the
screws （M3-0.5）.
5.Connect the power cable to power
supply and SATA cable to M/B.
6.Put the inner tray into outer
frame & lock it.
Note: When you push the inner tray in, please raise the handle
as horizontal state. While you can't push any longer,
please put the handle down, then the inner tray will be
connected to the outer frame at the same time.
The handle isn't in horizontal
state when you push in.

5
Caution
1. Make sure the "Key Lock" is at position "Lock" after the
installation of mobile rack.
2. If the HDD does not work after turning on the power of your
PC, please check the "Power" and SATA connectors for any
possible errors.

7