ENGO CONTROLS EREPEATERZB User manual

Quick Guide
Ver. 1
Release date: III 2023
Distributor:
QL CONTROLS Sp z o.o. Sp. k.
43-262 Kobielice
4 Rolna St.
Poland
Producer:
Engo Controls S.C.
43-200 Pszczyna
3E Górnośląska St.
Poland
ZigBee network repeater
www.engocontrols.com
EREPEATERZB
REPEATER
Repeater increases wireless network signal range for all Engo devices which works over
ZigBee 3.0 protocol. It helps to improve radio signal range in places, where wireless
network is disturbed by distance or other obstacles (concrete walls, reinforced ceilings,
etc.). This device cannot operate standalone. IIn order to use it EGATEZB ZigBee 3.0
gateway is needed.
INTRODUCTION:
This product must be used with EGATEZB ZigBee 3.0 gateway (purchased separately).
PRODUCT COMPLIANCE:
SAFETY INFORMATION:
WARNING:
WARNING:
Use in accordance with national and EU regulations. Use the device only as intended,
keeping it in a dry condition. The product is for indoor use only. Please read the entire
manual, before installation or use.
For the entire installation, there may be additional protection requirements, which the
installer is responsible for.
This product complies with the following EU Directives:
2014/30/EU, 2014/35/EU, 2014/53/EU, 2011/65/EU.
Technical specication:
Power supply 230V AC
50Hz
Communication ZigBee 3.0
2,4GHz
Dimensions
[mm] 40 x 24 x 82
LED diode indications
EXPLANATION
LED diode
ashes
blue
The device is in pairing
mode with ZigBee
network (when device
didn’t previously
added to the ZigBee
3.0 network, or after
recovery factory reset)
LED diode
lights up
blue
The device has been
added to the ZigBee
3.0 network
LED diode
is o
Repeater is not
connected to power
supply 230V

To register a new account,
please follow the steps
below:
Enter the verication code
received in the email.
Remember that you only
have 60 seconds to enter
the code!
Then set the login
password.
Enter your e-mail
address to which the
verication code will
be sent.
STEP 2 - REGISTER THE NEW ACCOUNT
To register a new account, please follow the steps below:
13
24
Installation of the repeater in the app
STEP 1  DOWNLOAD ENGO SMART APP
Make sure your router is within range of your smartphone. Make sure you are connected to
the Internet.This will reduce the pairing time of the device.
Download the ENGO Smart app from Google Play or Apple App Store and install it on
your smartphone.
STEP 3 - INSTALLATION OF THE ZigBee 3.0 REPEATER IN THE APP
Name device and click„Done”.
3x
The repeater is installed. Blue
LED diode is steady and app
shows main interface.
In the app, select:
„Add Device”.
Make sure the repeater is connected to
power supply.The blue LED should flash.
If not, perform factory reset
(check„Factory reset”section).
Make sure you have added
ZigBee gateway to app
Once the ZigBee gateway will
search correctly the repeater
click„Add”.
After installing the app and creating an account:
5
3
4
1 2
3
Unplug and plug again the repeater three times at intervals of 3
seconds. The LED on the device will ash, which means repeater has
been removed from the ZigBee network and gateway. After that
repeater will enter pairing mode automatically. You can add it back to
the ZigBee network (check„STEP 3”section).
Factory Reset (entering the pairing mode)
6