Enhanced Beverage Solutions AfterBurner User manual

Turbo Boost Your Nitro Infuser
The Enhanced Beverage Solutions’ AfterBurner
installs after your Nitro Infuser, right before the tap.
(ip for installation instructions)
© Enhanced Beverage Solutions | October 2019 | Revision 3.0 | Patent Pending
www.enhancedbeveragesolutions.com | @enhancedbeveragesolutions | #TapCulture
Stout
Faucet
To AfterBurner
Beverage
Gas Output
To Faucet
*Barbs on AfterBurner are permanently
axed and not designed to be removed.
REMOVAL OF BARBS VOIDS WARRANTY

Installing Your AfterBurner
Step 1: Preparation
Step 2: Cut Beverage Line
Step 3: Connect AfterBurner
Step 4: Repressurize
Cleaning
If you are installing your AfterBurner in an existing system, the nitrogen gas must
be shut o and depressurized, including the keg. Set the regulator to 0 psi. Open
the tap faucet to release pressure.
Identify the line from the Nitro Infuser to the faucet. Cut the line at a point that will
allow the AfterBurner to sit as close to the faucet as possible.
Please note: If you have a particularly long draw, your AfterBurner will sit further
away from your Nitro Infuser.
Connect the line from the Nitro Infuser Output to the Afterburner Input. Secure with
hoseclamp. Connect the line from the faucet to the AfterBurner Output. Secure
with hoseclamp.
Repressurize your system to 28 psi and double check for leaks. Pour and enjoy!
Cleaning your tap lines will clean the system. It is recommended that you clean your tap lines
every 1-2 weeks. It is recommended to remove your stout nozzle and rinse daily.