Envision ScripTalk Station 2 User manual

QUICK START GUIDE

Congratulations on your new ScripTalk
Station 2! This Quick Start Guide will help
you get started on your way to safety,
privacy and independence in managing
your prescription medications
What’s In the Box?
ScripTalk Station
2 Reader
Sample
Bottle
4 AA
Batteries
Power
Adapter
2

The Buttons
On/O
Volume
Switch
There is an O/O Volume switch and
three buttons that will allow you to
manipulate the reader and access the
information on your prescription labels.
3

About the Electronic Label
The talking label may be found:
• on the bottom of
your bottle or
container
• on the side of
your bottle or box
Due to packaging or medicine
content, your label may be
attached as an annex tag.
To access the electronic
label, lift it away from the
package when scanning.
4

Powering the Unit
Connect the USB cable
adaptor to the port on the
left side of the reader.
Then plug the adapter
into a power source.
You can also use 4 AA alkaline batteries
to power your unit. The battery access
door is on the back of the unit.
If you are using batteries
and forget to turn the unit
o, it will beep every couple
of minutes to remind you
to turn it o.
5

Power and Volume Control
Turn the thumbwheel
switch down to power
on the unit.
To adjust the volume,
turn the thumbwheel
up or down.
To shut o the unit,
turn the thumbwheel
up until you hear a
click.
6

On-Board Help
To listen to the instructions on how to
use the unit, press and hold READ for
about three seconds. To stop the
instructions, press READ again.
Press Next or Previous to move through
the dierent topics.
Three
Seconds
7

Reading a Prescription Label
• To scan, press READ. You will hear
beeping.
• Place your label on the top of the
reader.
• Listen to the label information.
• To stop the speaking, press READ.
8

Scrolling Through the Information
While the unit is speaking the label
information, you can press NEXT or
PREVIOUS to move through the
information or to repeat an item.
9

Troubleshooting
Place your prescriptions
on the reader
individually. The unit
can only read one
label at a time.
If the unit cannot nd
or read a label, it
will give you a
warning. Have a
sighted friend or a family
member read the label
for you, and talk to your
pharmacist to see about
a new label.
Warning! Unable
to Read Label.
10

Changing the Voice Speed
To change the voice speed, press and
hold NEXT or PREVIOUS for three
seconds, then press NEXT or PREVIOUS
to nd the speed you like. Press READ to
set the speed.
3 Seconds Select Save
12

Spell Mode
You can have the information spelled
out if you don’t understand a word.
Select the slowest setting in voice speed.
It will say “Spell Mode.” Press READ to
select, then scan your label. Reset voice
speed to exit.
13

Accessories
A handy travel bag
is available for your
convenience. The
insulated zippered
bag is designed to
hold your reader
as well as your medications. And it’s
perfect for trips or organization of
your medications.
ScripTalk Travel Case $24.99
Headphones $15.99
14

For more information or assistance,
please contact us at:
En-Vision America
825 4th St W
Palmetto, FL 34221
Toll Free: [phone]
Fax [phone]
[e-mail]
www.envisionamerica.com