enware WaterMark CDF300DC User manual

Version: Nov 16
Call 1300 369 273
www.enware.com.au
Enware Australia Pty Limited
9 Endeavour Rd Caringbah NSW 2229 Australia
Ph: 02 8536 4000 Fax: [phone]
CDF300DC
Barrier Free Wall Mounted Drinking Fountain with Chiller
CLEARANCE 305mm
MOUNTING FRAME
WIDTH 101.6mm
864
686
708
WASTE
729
SUPPLY
473
Product Code
CDF300DC Wall Mounted Round Bowl Barrier Free Drinking
Fountain with Chiller
FEATURES
Drinking Fountain
• Polished chrome-plated brass
bubbler & push button
• Satin finish waste strainer
• Vandal-resistant bottom plate
• Special mounting plate
• Brushed Finish 18 gauge Type
304 Stainless Steel
• Removable lower panel for easy
installation
Chiller
• Provides up to 30l/hour of mains
pressure chilled water.
• Stainless steel storage tank and
pipework
• Louvered front ventilation panel
• Easy access for maintenance
• Environmentally friendly R134A
refrigerant
• Optional carbon filter available
A sophisticated stainless steel barrier-free drinking fountain,
with stylish sculpted round bowl and under counter chiller unit.
With a one-piece matching brushed finish back panel and vandal
resistant bottom plate. Bubbler and push button are polished
chrome-plated brass. Waste strainer has a satin finish.
Enware tapware must be installed in accordance with the provisions of AS/NZS3500 and any
relevant local regulations. Installations not complying with AS/NZS3500 may void the product
and performance warranty provisions.
Drinking Fountain
Inlet Connection ½” BSP Female
Minimum Supply Line Size ½”
Waste Water Outlet Connection 1-1/2” BSP (40mm) Male
Technical Information
Chiller
Flow Rate 30 lph
Refrigerant R134A
Power Supply 240V/50Hz
Power Connection 3 pin 7.5A Plug with 1.8m lead
Working Pressure Range 200 - 500 kPa
Dimensions 437H x 338W x 261D
This product is disability friendly, designed to the technical
requirements of the ADA (American Disability Act 2010
- Standards for Accessible Design), however it does not
comply in full with AS1428.2 1992
A
TS5200.105 WM-022628
IAPMO R&T OCEANA

Version: Nov 16
Call 1300 369 273
www.enware.com.au
Enware Australia Pty Limited
9 Endeavour Rd Caringbah NSW 2229 Australia
Ph: 02 8536 4000 Fax: [phone]
Barrier Free Wall Mounted Drinking Fountain with Chiller
35mm
NOTES
1. HOLD ROUGH-IN DIMENSIONS ±1/8” (3.2MM)
2. WHEN INSTALLING THIS UNIT. LOCAL STATE OR NATIONAL
CODES SHOULD BE ADHERED TO. FOR DIMENSIONS
(LOCATIONS), WASTE AND SUPPLY REQUIREMENTS OTHER
THAN SHOWN, DIMENSIONS MARKED * MUST BE ADHERED
TO ACCORDINGLY.
3. INSTALLER MUST PROVIDE A MAINTENANCE MANUAL
FOR PUSH BUTTON AND VALVE INSTALLATION/
MAINTENANCE INSTRUCTIONS
REFER TO 5874SS OPERATION AND MAINTENANCE
MANUAL FOR PUSH BUTTON AND VALVE INSTALLATION/
MAINTENANCE INSTRUCTIONS
INSERT 5/16”-18 PANEL INSERTS FROM OPPOSITE SIDE AT
LOCATIONS SHOWN BY DARKENED HOLES
FOUNTAIN REMOVAL: FIRST REMOVE SCREWS AND THEN
SQUEEZE CLIPS ON NUT RETAINER TO POP OUT.
INSTALL IS REVERSE OF REMOVAL.
ALIGN HOLES IN CHILLER SUPPORT TRAY WITH HOLES IN
FRAME AND FASTEN WITH #10 SHEET METAL SCREWS