Enwork XTB4 User manual

XTB4 Topper Screen (53”H) Installation Guide – Rev A.
For 53” Double or Single Sided, Acoustic or Acrylic.
XTB4 TOPPER SCREEN
INSTALLATION GUIDE (53”H)
SCREENS
UN0003
WARNING:
Acrylic screens scratch and scuff easily. After removing
protective lm, immediately and carefully install the screen.
DO NOT remove protective lm from acrylic screens, then stack
them in a pile or against each other. Experience shows this will
cause marring and scratching.

INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
XTB4 Bench
(Single or Double Sided)
Rear Bracket (2x)
M6 x 1 x 12mm Button Head
Hex Drive Screw (2x or 4x)
Screen Gusseted Bracket (2x or 4x)
10-24 x 3/8 1/2 Binding Bolt
Phillips/Truss Head (4x)
M6 x 1mm Flange Locknut (4x)
10-24 x ¾ 7/8 Binding Bolt
Phillips/Truss Head (4x)

INSTALLATION GUIDE
2) TOOLS AND SUPPLIES REQUIRED
Drill/ Screwdriver
Socket Wrench
Screw Driver (2x) 4mm Hex Bit
10mm Socket

INSTALLATION GUIDE
ACRYLIC OR ACOUSTIC DOUBLE
SIDED (PAGES 5-6)
ACRYLIC OR ACOUSTIC SINGLE
SIDED (PAGES 7-8)
3) ASSEMBLY OVERVIEW

INSTALLATION GUIDE
1. Complete the necessary steps noted in the
installation instructions UN0001 before proceeding.
2. Attach two of the Gusseted Brackets on each
side of the Screen using the provided 10 24 x 3/8-
1/2 Binding Bolts.
Note: The Acoustic Screen will use the 10 24 x ¾
7/8 Binding Bolts.
3. Locate the Screen assembly over the End Link
Tube holes using the M6 x 1 x 12mm Button Head
Hex Drive Screws.
FIGURE 1
FIGURE 2
FIGURE 3
3) ASSEMBLY: ACRYLIC OR ACOUSTIC
DOUBLE SIDED SCREEN
4x
2x

INSTALLATION GUIDE
4. Secure the Screen Assembly by tightening
the provided M6 x 1mm Flange Locknuts.
Enjoy!
FIGURE 4
FIGURE 5
3) ASSEMBLY: CONT.
4x

INSTALLATION GUIDE
1. Complete the necessary steps noted in the
installation instructions UN0001 before proceeding.
2. Attach a Gusseted Bracket on one side of the
Screen and a Rear Bracket on the other side using
the provided 10 24 x ¾ 7/8 Binding Bolts.
Note: The Acrylic Screen will use the 10 24 x 3/8-
1/2 Binding Bolts.
3. Locate the Screen assembly into the End Link
Tube holes.
FIGURE 1
FIGURE 2
FIGURE 3
3) ASSEMBLY: ACRYLIC OR ACOUSTIC
SINGLE-SIDED SCREEN
2x

INSTALLATION GUIDE
5 . Secure the Screen Assembly by tightening
the provided M6 x 1mm Flange Locknuts.
Enjoy!
4. Secure the Gusseted Bracket using the provided
M6 x 1 x 12mm Button Head Hex Drive Screw.
FIGURE 5
FIGURE 6
FIGURE 4
3) ASSEMBLY: CONT.
2x
4x

Specications subject to change without notice.
Rev 07.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331