Enwork Zori User manual

Zori Freestanding Single Screens Installation Guide – Rev B.
ZORI FREESTANDING SINGLE
SCREEN INSTALLATION GUIDE
SCREENS
ZI0001
WARNING:
Acrylic screens scratch and scuff easily. After removing
protective lm, immediately and carefully install the screen.
DO NOT remove protective lm from acrylic screens, then stack
them in a pile or against each other. Experience shows this will
cause marring and scratching.

INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
Screen Assembly
Zori Foot Casting - CYX-1022-15
(Mobile Option)
5/16-18 Steel Nylon Insert Locknut
(Mobile Option)
Screen Foot - FRM-1910
(Freestanding Option)
Zori Foot Casting - CYX-1022-15
(Mobile Option)
10-24 x 1” Phillips Flat Head Type F
(Freestanding Option)
5/16-18 x 1 1/4” Serrated Flange Bolt
(Mobile Option)

INSTALLATION GUIDE
2) TOOLS AND SUPPLIES REQUIRED
Drill Hex Driver Bit Combination Wrench
(Ratcheting Suggested)

INSTALLATION GUIDE
1. Lay Screen Assembly at one non-
marring surface large enough to support
the metal framework.
2. Attach the Foot using (3) 10-24 x 1 Square Drive
Flat Head
Repeat for the other foot.
3. Place in upright position
Assembly complete
FIGU RE 3.1
FIGURE 3.2
FIGURE 3.3
3) ASSEMBLY: FREESTANDING SCREEN

INSTALLATION GUIDE
1. Lay Screen Assembly at one non-
marring surface large enough to support
the metal framework.
2. Align the 5/16-18 Steel Nylon Insert Locknut in
the Foot Casting and assemble using the 5/16-18 x
1 1/4” Serrated Flange Bolt
3. Thread in the 80mm Twin Wheel Locking Caster
into the Foot Castings
FIGU RE 4.1
FIGURE 4.2
FIGURE4.3
4) ASSEMBLY: MOBILE SCREEN

INSTALLATION GUIDE
4. Place in upright position
Assembly complete
FIGURE 4.4
4) ASSEMBLY: MOBILE SCREEN CONT.

Specications subject to change without notice.
Rev 11.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331