Enwork Skyline User manual

Skyline Removable Bracket Panel Topper Installation Guide – Rev B.
SKYLINE REMOVABLE TOPPER
SCREEN INSTALLATION GUIDE
SCREENS
TI0051
WARNING:
Acrylic screens scratch and scuff easily. After removing
protective lm, immediately and carefully install the screen.
DO NOT remove protective lm from acrylic screens, then stack
them in a pile or against each other. Experience shows this will
cause marring and scratching.

INSTALLATION GUIDE
1) PARTS AND FASTENERS INCLUDED
Screen Panel
(Acryic or Acoustic)
Tape
10-24 X .375-.50 BINDING BOLT
Clamp Bracket
PNM-1948
Bracket
PNM-1947
Thumb Screw
2) TOOLS AND SUPPLIES REQUIRED
2x Phillips Screw Drivers

INSTALLATION GUIDE
Each screen will use (3) PNM-1947 Brackets and
(1) PNM-1948 Clamp Bracket.
Sandwich the Acrylic or Acoustic Panel Screen
between the Brackets, aligning the holes in the
screen and the bracket. Attach them all together
with the Binding Bolt (FIGURE 1).
The screen may or may not be symmetrical
(FIGURE 2). The large radii corners need to be at
the front of the worksurface, where the user sits.
Remove the backer from one side of the double
sized tape and apply it, centered, to each of the
PNM-1947 Brackets. Both pieces should go onto
the Pair seen of the of the PNM-1947 Brackets
(FIGURE 3).
Clean the worksurface with Isopropyl Alcohol.
Peel the second backer off the tape pieces and
place the assembly in its desired location. Hold the
assembly down rmly for 30 seconds to activate
the tape.
NOTE: The tape cure time is 24 hours. Please
allow tape to cure before using screen.
FIGURE 1
FIGURE 2
FIGURE 3
3) ASSEMBLY:

INSTALLATION GUIDE
Assembly the thumb screw into the PNM-1948
Clamp Bracket and tighten (FIGURE 4).
FIGURE 4
3) ASSEMBLY:

Specications subject to change without notice.
Rev 11.2020
1.800.815.7251
www.enwork.com
12900 Christopher Dr. Lowell, MI 49331