Epic Office Furniture Modulus User manual

TOOLS REQUIRED: Powered screwdriver.
Modulus Single Post
Pedestal Table
Installation Guide

INSTALLATION GUIDE
Modulus Single Post Pedestal Table
COMPONENTS
1Steel Plate x1
2Feet Tube x1
3Large Foot x4
4Cross Collar x1
5Foot Glides x4
6Cross Gasket x1
7Table Top x1
SCREWS
8M5x20mm Self Tapping x4
9M8x16mm x4
10 M10x110mm x1
11 M8x30mm x3
1
7
2
3
5
10
8
11
6
4
9

INSTALLATION GUIDE
Modulus Single Post Pedestal Table
01
03 04
02
Place the feet tube into the cross collar, making sure the notch in the bottom of the
tube is in-line with the bump inside the cross collar Fig A. Fully tighten the large M10
bolt, spring washer and flat washer through the gasket and collar into the tube.
Slide the 4 large feet into the cross collar. Place the cross gasket on top of the feet
and collar, and tighten 4xM5 screws into the cross collar.
Locate the steel plate on top of the feet tube, and line up the 3 holes. Fully tighten
the 3 screws into the tube.
Screw the 4 glides into the base of the large feet, leaving the glides one turn from
tight (then they can be adjusted easily if the floor is uneven).
Fig A

INSTALLATION GUIDE
Modulus Single Post Pedestal Table
06
Fully tighten the last 4 self tapping screws into the work surface.
05
With the frame assembled, place it upside down onto the work surface, and
measure the top from all sides to make sure it’s centered.