Eplus Speed Unlocker User manual

[email protected]e // www.eplus.bike
Via Pontestura 124 Camino 15020 (AL) Italy
eplus
1.1 VERSION
INSTALLATION
BROSE ENGINES

2. INSTALLATION
INSTALLATION
Device connection
ATTENTION
It is forbidden by law to activate EPLUS speed unlocker in public places such as streets,
squares and cycling paths. So it is only possible to activate EPLUS speed unlocker in private
places such as circuits and private properties.
The maker denies responsibility due to any damage to pedal assisted bicycles
where Eplus is set up. The maker denies responsibility due to any harm to people or objects.
Unplug the connectors
and locate the wires
Before starting, unplug the battery.
Dissemble the left pedal with an extractor.
1

3. INSTALLATION
2
3
Unplug the plastic carter.

4. INSTALLATION
4
5
Unplug the 4-wires connector next to the engine.
Unplug the 2-wires connector of the speed sensor next to the engine (4,5,6)
Unplug the connectors
and locate the wires

5. INSTALLATION
Install the cable clamp (blue plug supplied with the installation kit) on the connector cables
with 2 cords of the speed sensor using the following scheme of colours:
Black on the sensor connector / Black Eplus side
Red on the sensor connector / White Eplus side
6
HMI SPEED SENSOR
7

6. INSTALLATION
Unplug the connectors
and locate the wires
8
9

7. INSTALLATION
For a correct installation, the cable clamp
has to be perfeclty closed.
OK
NO

8. INSTALLATION
Install the cable clamp on the 4-wire connector cords using the following scheme of colours:
Blue on the connector / Yellow Eplus side
Green on the connector / Green Eplus side
Red on the connector / Red Eplus side
Install the cable clamp
10
For Brose engines

9. INSTALLATION
2
3
1 45
Assembly diagram for Brose engines
6
NB. The black cord can be connected indierently, as shown on the installation scheme,
to the black cord, (connection n.5) or to the brown cord (connection n.6)
HMI Connector Speed sensor

10. INSTALLATION
Install the cable clamp on the 4-wire connector cords using the following scheme of colours:
Black on the connector / Yellow Eplus side
Green on the connector / Green Eplus side
Orange on the connector / Red Eplus side
Install the cable clamp
11
For Brose S engines

11. INSTALLATION
CONNETTORE HMI SENSORE VELOCIT
À
2
3
1 45
Assembly diagram for Brose S engines

[e-mail] // www.eplus.bike
Via Pontestura 124 Camino 15020 (AL) Italy
eplus
12-months warranty .
We are responsible for manufacturing faults but not for the installation
problems. Store it in dry places and far from heat sources.