Epson ET-2720 User guide

SUPPORT
GOTEK
The technical specifications and performance capabilities listed herein are subject to change at any time and may not reflect actual production capabilities. Graphics One is
not responsible for any incorrect information contained herein and urges any buyer or potential buyer to test the product prior to making a purchase.
TB-15000
136-20
2. Unpacking the ink bottles (Follow the Instructions)
ET-2720 Start up Guide
How to load SubliMate™ Ink
This guide describes the procedure on how to load Inksinto the printer.
1. Unpack and remove all protective materials from the product.
3. Filling the ink tanks.
a. Open the ink tank cover, then open the cap for the ink
tank you are going to fill
c. Put the lower part of the cap
back on the bottle and load the inks
as shown.
b. Unscrew the entire Cap. Break or
remove the Aluminum Seal
a. Take the bottle out of the poly bag
and remove the Black Tape

b. Position the top of the ink bottle along the
slot in front of the filling port, then slowly stand
the bottle up to insert it. Wait for ink to fill the
tank
Do not squeeze the bottle. Ink flows into the tank and stop
automatically when the ink tank is full.
Repeat steps 3a-3c to fill the rest of the ink tanks, close the
ink tank cover when finish.
c. Remove the ink bottle once the ink tank is full and securely
close the ink tank cap.
SUPPORT
GOTEK
The technical specifications and performance capabilities listed herein are subject to change at any time and may not reflect actual production capabilities. Graphics One is
not responsible for any incorrect information contained herein and urges any buyer or potential buyer to test the product prior to making a purchase.
TB-15000
136-20
4. Connect the power cord to the back of the product and to an electrical outlet. Raise the con-
trol panel, then press the power button to turn on the product. (Do not connect to the computer
yet)
5. Press up or down arrows to select your language, date and time on the LCD screen. Next,
press the OK button. When the message “Start Here” appears on the LCD screen, press the
OK button. On the next screen, press and hold the button for 5seconds.
6. When the message to “Start Initialization” appears on the LCD screen, press the start button
to start charg-ing the ink. Ink charging takes approximately 30 min-utes. A message will appear
when ink charging is complete. (Do not turn off or unplug the printer or perform any other
operations during ink charging or you'll waste ink).
7. Go to https://epson.com/Support/Printers/All-In-Ones/ET-Series/Epson-ET-2720/s/
SPT_C11CH42201
8. Download your Printer Driver follow the
instructions and install it.
9. Connect the printer using a USB/Network Cable or
WiFi, the driver wizard will guide you in this process.
Once done, you machine is ready to be used