Equator 2440 User manual

There is one button, located at the center of the control panel, to
turn the dishwasher on or off and also to start the wash program.
Press the On/Off button for 3 seconds to power the appliance on.
Select the Wash Programs by pressing the Program button. Once
selected, the Program number (e.g. P1, P2) flashes on the Display
Panel and also the number of minutes for the cycle.
If Program button is held down for 3 seconds, the program is
cancelled.

Half Load button - Press this button to select either upper or lower
basket, if dishwasher is only half full. The red LED light will show
your selection.
Delay button - You can delay the start of the program.
Pressing this button will ad time in one-hour increments.
to cancel Delay, press and hold the Start button for 3 seconds.
Options button - You may select:
Sanitize - increases the water temperature in the final rinse.
High Temp - increases water temperature and wash time.
Extra Dry - increases water temperature.
Rinse Aid - If rinse aid needs to be added, the Rinse Aid indicator
light will illuminate.
Start / Pause button