Equator WR 14 User manual

Wine Cooler
WR 14
OWNER’S MANUAL

1
IMPORTANT SAFETY INSTRUCTIONS
~WARNING~
Follow these basic precautions to reduce the
risk of fire, electrical shock, or injury when
using your appliance,
•Read all instructions before using the appliance.
•DANGER: Risk of child entrapment.
Discarded or abandoned appliances are still dangerous. . . even if they will “just sit in the
garage a few days.”
•Before you throw away your old appliance: Take off the doors. Leave the shelves in
place so that children cannot easily climb inside.
•Never allow children to operate, play with, or crawl inside the appliance.
•Never clean appliance parts with flammable fluids. The fumes can create a fire hazard or
explosion.
•Do not store or use gasoline or any other flammable vapors and liquids in the vicinity of this
or any other appliance. The fumes can create a fire hazard or explosion.
-Save these instructions-
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR APPLIANCE
•Remove the exterior and interior packing.
•Check to be sure you have all of the following parts:
•2Shelves
•1Wine Rack
•1 Owner’s Manual
•Before connecting the appliance to the power source, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
•Clean the interior surface with lukewarm water using a soft cloth.
INSTALLING YOUR APPLIANCE
•This appliance is designed to be free standing only, and should not be recessed or built-in.
•Place your appliance on a level floor that is strong enough to support the appliance when it is
fully loaded. To level your appliance, adjust the front leveling leg at the bottom of the
appliance.
•Allow 5 inches of space between the back and sides of the appliance, which allows the proper
air circulation to cool the compressor.
•Position the appliance away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the appliance not to
perform properly.
•Avoid placing the appliance in moist areas.
•Plug the appliance into an exclusive, properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
authorized Equator Products service center.
ELECTRICAL CONNECTION
~
Warning
~
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged, have it replaced by an authorizedelectrician orEquator serviceagent.

2
This appliance should be properly grounded for your safety. The power cord of this appliance is
equipped with a three-prong plug which mates with standard three prong wall outlets to minimize the
possibility of electrical shock.
Do not under any circumstances cut or remove th e third ground prong from the power cord supplied.
For personal safety, this appliance must be properly grounded.
The cord should be secured behind the appliance and not left exposed or dangling to prevent
accidental injury.
The appliance should always be plugged into its own individual electrical outlet which has a voltage
rating that matches the rating label on the appliance. This provides the best performance and also
prevents overloading house wiring circuits that could cause a fire hazard from overheated.Never
unplug the appliance by pulling the power cord. Always grip the plug firmly and pull straight out from
the receptacle. Repair or replace immediately all power cords that have become frayed or otherwise
damaged. Do not use a cord that shows cracks or abrasion damage along its length or at either end.
When moving the appliance, be careful not to damage the power cord.
REVERSING THE DOOR SWING OF YOUR APPLIANCE–
This appliance has the capability of the door opening from either the left or right side. The unit is
delivered to you with the door opening from the left side. Should you desire to reverse the opening
direction, please call customer service for reversal instructions.
OPERATING YOUR APPLIANCE
TEMPERATURE SETTING
•The thermostat knob of the wine cooler is set at the factory in the middle position.
•The wine cooler should be plugged in and allowed to run for 24 hours before making any
temperature adjustments.
•The temperature can be adjusted by turning the thermostat knob.
•The ideal temperature range for storing wines is 50-57°F.
•Wine stored in the wine cooler will be at the set temperature after 10 hours of storage.
STORAGE
Many bottles may differ in size and dimensions. As such the actual number of bottles you may be able
to store may vary.
CARE AND MAINTENANCE

3
CLEANING YOUR APPLIANCE
•Unplug the appliance, and remove shelves.
•Wash the inside surfaces with a warm water and baking soda solution. The solution should be
about 2 tablespoons of baking soda to a quart of water.
•Wash the shelves with a mild detergent solution.
•The outside of the appliance should be cleaned with mild detergent and warm water.
•Wring excess water out of the sponge or cloth before cleaning the area of the controls, or any
electrical parts.
•Wash the outside cabinet with warm water and mild liquid detergent. Rinse well and wipe dry
with a clean soft cloth.
CAUTION:
Failure to unplug the appliance could result in electrical shock or personal injury.
POWER FAILURE
Most power failures are corrected within a few hours and should not affect the temperature of
your appliance if you minimize the number of times the door is opened.
NOTE: If the unit is unplugged, has lost power, or is turned off; you must wait 3 to 5 minutes before
restarting/reconnecting the unit. If you attempt to restart before this time delay, the appliance will not
start.
VACATION TIME
•Short vacations: Leave the appliance operating during vacations of less than three weeks.
•Long vacations: If the appliance will not be used for severalmonths, remove all items and unplug
the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave
the door open slightly, blocking it open if necessary.
MOVING YOUR APPLIANCE
•Securely tape down all loose items inside your appliance.
•Turn the leveling screw up to the base to avoid damage.
•Tape the doors shut.
•Be sure the appliance stays secure in the upright position during transportation. Also protect
the outside of appliance with a blanket or similar item.
ENERGY SAVING TIPS
•The appliance should be located in the coolest area of the room, away from heat producing
appliances, and out of the direct sunlight.
TROUBLESHOOTING GUIDE
You can solve many common appliance problems easily, saving you the cost of a possible service

4
call. Try the suggestions below to see if you can solve the problem before calling the servicer.
PROBLEM POSSIBLE CAUSE
Appliance does not operate. Not plugged in.
The circuit breaker tripped or a blown fuse.
Appliance is not cold enough. Check the temperature control setting.
Make sure the unit is away from direct sunlight
and heat sources.
The door is opened too often.
The door is not closed completely.
The door gasket does not seal properly.
Turns on and off frequently. The room temperature is hotter than normal.
The door is opened too often.
The door is not closed completely.
The temperature control is not set correctly.
The door gasket does not seal properly.
Vibrations. Check to assure that the appliance is level.
The appliance seems to make too much noise. The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling
sounds caused by the flow of refrigerant in your
appliance.
Contraction and expansion of the inside walls
may cause popping and crackling noises.
The applianceis not level.
The door will not close properly. The appliance is not level.
The door was reversed and not properly installed.
The gasket is dirty.
The shelves are out of position.

5
CONTACT INFORMATION
SERVICE & SUPPORT:
[email protected]
[phone]
Equator Advanced Appliances
2801 W Sam Houston Parkway N, Suite125
Houston, TX 77043-1611
Phone: [phone] Fax: [phone]
All rights reserved.
Manual subject to change without notice