Installation & Notice
Choose a suitable position and fix the mounting plate on the
ceiling with screws. Fasten the Sensor on the mounting plate
in a clockwise direction. It is suggested to mount it at the
height of 2.5-5 meters from the ground.
Keep the Sensor away from air conditioner, electronic fan,
refrigerator, oven, heater or any other objects which will
cause fast temperature changing.
Avoid mounting it in direct sunlight or any objects blocking
the lens, so as not to influence the detection effect.
Testing (Walk Test)
After installation, power on the Sensor After self-testing for 1
minute, press the test button, walk in the scope by crossing
the infrared spectrum (see below diagram), and watch the
LED indicator to make sure it is working. The LED indicator
will flash once when body movement is detected.
High detection sensitivity
Low detection sensitivity
Connect with the Control Panel
When the control panel is in connecting state, press the test
button twice to send wireless signal. One beep is heard after
panel receives signal, which means successful connection.
Arm the system, trigger the Sensor again. The panel will
alarm immediately. This indicates the Sensor has successfully
connected with the panel.
Specifications
Power Supply:
DC 3V (AA LR6 1.5V Battery x 2pcs)
Static Current:
13uA
Alarm Current:
15mA
Installation Height:
2.5-6m
Detection Scope:
Dia. 6m (when installation height is 3.6m)
Transmitting Distance:
80m (in open area)
Radio Frequency:
433.92MHz
Housing Material:
ABS Plastic
Operation Condition
Temperature: 0°C~+55°C
Relative Humidit (non-condensing)y: <80%
Detector Dimensions (L x W x H):
90 x 90 x 36.8mm
Mounting Plate Dimensions (L x W x H):
56 x 56 x 8mm
<
<
<
PRODUCT GUARANTEE *
We at ERA firmly believe in the quality of our goods. Our
technology achieves outstanding performance and durability and
we can therefore offer, in addition to your statutory rights, an
additional limited guarantee. In the event of any material defects in
any product manufactured by us due to faulty design, materials
and/or workmanship, and which arise following correct installation
and during normal use in accordance with our instructions, as
included in the product packaging, within the period of two years
from the date of purchase, we will either repair, provide a
replacement, substitute with an equivalent product free of charge
from our then current range or refund in full the amount paid for
the product at point of purchase.
Conditions
In order to take advantage of our guarantee, you must comply with
the following conditions:-
1. This limited guarantee is not transferable and is extended only to,
and is solely for the benefit of, the original purchaser of the
product. Please retain your dated sales invoice as proof of
purchase and forward this to us if you wish to make a claim
under this guarantee.
2. Products must be installed, used and maintained in accordance
with our instructions otherwise the guarantee will be invalidated.
3. The product must not be damaged or modified in any way nor
must it have been subjected to any unauthorised repairs.
Exclusions
This guarantee does not cover:-
1. Periodic maintenance, repair and replacement of parts due to fair
wear and tear.
2. Abuse or misuse, including but not solely limited to the failure to
use this product for its normal purposes or in accordance with
ERA's instructions on usage and maintenance.
3. Failure of the product arising from incorrect installation or use not
consistent with the instructions supplied and the cost of any
removal or installation of products.
4. Accidents, Acts of God, lightning, water, fire, public disturbances,
improper ventilation, voltage fluctuations or any cause beyond
the control of ERA (Force Majeure).
5. Unauthorised modifications carried out to the product.
6. Damage caused by incorrect/improper use of supplied batteries.
7. Alteration to, deletion, removal or illegibility of the Serial Number
as shown on the Product Label.
8. Consumables: any damages so caused by the use of batteries
not supplied by ERA.
9. Repair or attempted repairing by bodies who are not ERA
authorised repairers.
10. Neglect.
11. The loss of any stored data on your product.
This guarantee is in addition to your contractual and statutory
rights and does not affect your statutory rights
To make a claim
Please contact Customer Support either by telephone on 0345 257
1000 or email with full details of your claim. info@eramiguard.com
If your claim satisfies our Conditions and is not subject to any of our
Exclusions, we will agree with you the repair, replacement,
substitution or refund of payment of goods. For product returns
you will be issued with a Return Authorisation Number (RAN).
Please note: Returns will not be accepted unless accompanied by a
RAN.
*Terms and conditions apply. P700_UM_V1_4616
