eSID 03-06 User manual

www.esid.se
Page:
1 / 43
Na
me of document:
eSID 03-06 User Guide
V
ersion:
1.2
eSID 03-06
User Guide
extended Saab Information Display (eSID)
for new generation Saab 9-3 (MY2003-200 )
with HPD (High Position Display)

www.esid.se
Page:
2 / 43
Na
me of document:
eSID 03-06 User Guide
V
ersion:
1.2
Introduction ...................................................................................................................... 4
eSID 03-06 components ..................................................................................................... 5
eSID-HPD .................................................................................................................................. 5
eSID-GW ................................................................................................................................... 5
Current consumption ................................................................................................................ 5
User Interface ................................................................................................................... 6
Transition between Active and Passive state ............................................................................. 7
Auto start .................................................................................................................................
Welcome Message ....................................................................................................................
Display ............................................................................................................................. 9
Main View ................................................................................................................................ 9
Status View ............................................................................................................................ 10
Display Units .......................................................................................................................... 10
Display Illumination ................................................................................................................ 11
Display Group: avorites ................................................................................................. 12
Display Group: Powertrain .............................................................................................. 13
Momentary Fuel ..................................................................................................................... 13
Accumulated Fuel Consumption .............................................................................................. 14
Average Fuel Consumption ..................................................................................................... 15
Torque/Power ........................................................................................................................ 16
Intake Air Temperature / Coolant Temperature ....................................................................... 17
Transmission Oil Temperature ................................................................................................ 1
Engine Speed / Vehicle Speed ................................................................................................. 19
Maximum Torque / Power ...................................................................................................... 20
Airmass .................................................................................................................................. 21
Turbo Boost pressure .............................................................................................................. 22
Ethanol Blend ......................................................................................................................... 23
Diesel DPF Data ...................................................................................................................... 24
Performance........................................................................................................................... 25
Display Group: Vehicle .................................................................................................... 26

www.esid.se
Page:
3 / 43
Na
me of document:
eSID 03-06 User Guide
V
ersion:
1.2
Drive Time .............................................................................................................................. 26
Acceleration ........................................................................................................................... 27
Battery/Crank Voltage ............................................................................................................ 2
Accumulated Distance ............................................................................................................ 29
Brake distance and time measurement ................................................................................... 30
Display Group: Diagnostics ............................................................................................. 31
Read DTC ................................................................................................................................ 31
Clear DTC................................................................................................................................ 32
Display Group: Settings ................................................................................................... 33
3 Blink .................................................................................................................................... 33
Manual Wiper speed interval .................................................................................................. 34
Automatic Foglight activation ................................................................................................. 35
Welcome Message .................................................................................................................. 36
Fuel correction factor ............................................................................................................. 37
Distance correction factor ....................................................................................................... 3
Auto Start ............................................................................................................................... 39
Extra functionality .......................................................................................................... 40
Custom main view .................................................................................................................. 40
Limitations ..................................................................................................................... 41
Not possible to change volume (ICM: 1) .................................................................................. 41
ICM system freezes and does not go to sleep or deactivate illumination (ICM: ALL) ................. 41
Not possible to change radio channel and CD track using steering wheel (ICM: 1 and 2) ........... 42
Not possible to hang up phone call (ICM: 2) ............................................................................. 42
Not possible to see Navigation directions (ICM: 3) ................................................................... 42
No seatbelt warning sounds (ICM: ALL) ................................................................................... 42
Switch illumination reduced (ICM: ALL) ................................................................................... 42
Parking Assist delayed activation (ICM: ALL) ............................................................................ 42
Not possible to activate Night Panel (ICM: ALL) ....................................................................... 42
Different view when eSID is going passive (ICM: ALL) ............................................................... 43

www.esid.se
Page:
4 / 43
Na
me of document:
eSID 03-06 User Guide
V
ersion:
1.2
Introduction
eSID 03-06 (here referred to as eSID) is an integrated add-on system to the Saab NG9-3 2003-2006
which gi es the dri er the possibility to read internal hidden performance data from the ehicle on
the normal display (SID) together with additional functionality like one-touch-three-blink-indications,
the manual wiper inter al function and the possibility to read all fault codes
*)
in the ehicle and ha e
them displayed on the integrated standard display.
*) All fault codes in the ehicle, not just the Engine emission codes like the basic diagnostic tools.
The standard display, SID (Saab Information Display) is controlled by the Infotainment System (more
specifically the Infotainment Control Module (ICM) and the SID control panel (SIDC).
The ICM exist in three-different equipment le els:
• ICM1 – No Display
• ICM2 – Monographic Display
• ICM3 – LCD Display
The figure below shows how these three components look like (Example equipped with ICM3):
Components related to the SID
The standard functionality is that the ICM unit reads the status of the switches/encoders from SIDC
and then controls the output to the SID accordingly.
One of eSID main objecti es is to be integrated with the original system and with a long press on the
INFO button on SIDC the SID will switch between ICM and eSID control, making the two systems work
side-by-side.
Note! It is strongly recommended to have ICM2 or ICM3 while using eSID due to limitations in the
Saab Infotainment System, please check the “Limitations” section in this manual.
It is also important to update the ICM system if possible and be aware that ICM could potentially
freeze and don’t go to sleep, please check the “Limitations” section in this manual.
SIDC
SID
ICM3

www.esid.se
Page:
5 / 43
Na
me of document:
eSID 03-06 User Guide
V
ersion:
1.2
eSID 03-06 components
The eSID 03-06 consists of two components: eSID-HPD that mainly controls the display and eSID-GW
that is a data collection and pre-processing unit.
eSID-HPD
HPD is short for “High Position Display” and was the internal de elopment name of the display
located near the windscreen on these model years (commonly known as SID, Saab Information
Display).
eSID-HPD needs to be installed behind the SID, in series with the display cables between ICM and
SID. See separate Installation Guide.
eSID-GW
eSID-GW (Gateway), needs to be placed in the diagnostic connector under the steering wheel abo e
the dri er feet. eSID-GW is easily installed within a few seconds.
Current consumption
It is always important to reduce the quiescent current consumption to a oid ha ing an empty
battery. If the ehicle needs to stand for a longer period of time its recommended to remo e the
eSID-GW from the OBD-connector.
eSID-GW does not ha e any memory and can be remo ed without losing any settings.
eSID-HPD stores all settings and keeps it also when the battery is remo ed.
Component
Quiescent Cur
rent
eSID
-
GW
9 mA
eSID
-
HPD
< 2 mA

www.esid.se
Page:
6 / 43
Na
me of document:
eSID 03-06 User Guide
V
ersion:
1.2
User Interface
eSID has two major states:
1. Passive Normal vehicle display functionality active
2. Active Display is completely controlled y eSID
eSID Activation/Deactivation
eSID Active
Display is completely controlled by eSID
eSID Passive
Normal vehicle
display functionality
active
Long press on INFO
• eSID will always start in last active display view and last active
display group
• Short press on INFO wheel to:
o Start Activate function in active display view
o Enter display group (if on root level)
• Short press on CLEAR switch to:
o Leave display group and go back to root level (if in
display group)
• Long press on CLEAR switch to:
o Reset function in active display view
Auto activation deactivation
Default (power
-
up)
INFO
INFO
CLEAR

www.esid.se
Page:
7 / 43
Na
me of document:
eSID 03-06 User Guide
V
ersion:
1.2
Transition between Active and Passive state
Switching between the states occurs:
a) If the dri er presses the INFO switch on the SIDC for more than 1.5 seconds a switch between
acti e and passi e state will occur.
Note! eSID can only go to acti e state if the Ignition Key is in ON.
b) If re erse gear is engaged on a ehicle with Parking Assist, the system will switch from acti e
to passi e state (if currently in acti e state). It will switch back automatically to acti e state
when re erse gear is no longer engaged
c) If a popup warning is triggered to be shown to the dri er (Icon and text) the standard system
requests the information icon in the instrument cluster to be acti ated (“ i “). eSID listens to
this request and will switch to passi e state (if currently in acti e state), to show the message
to the dri er.
Example warning that will trigger eSID to go passi e
d) When the dri er door is opened and the conditions to trigger the welcome message is
fulfilled it will switch from passi e to acti e state (and show the welcome message).
e) If Auto start is enabled it can trigger eSID to go from passi e to acti e state (see separate
section)
f) If the Ignition key is remo ed from the Ignition switch, the eSID will be switched to passi e
state.

www.esid.se
Page:
8 / 43
Na
me of document:
eSID 03-06 User Guide
V
ersion:
1.2
Auto start
The normal SID display will always be acti e (eSID passi e) when the key is inserted into the Ignition
Lock, this to ensure that all warning messages are taken care of before eSID is started.
If Auto start is enabled, eSID switches from passi e to acti e state when ehicle speed goes abo e 20
km/h if:
• No acti e warning/icon on the SID
• Dri er seatbelt attached
• Auto start has not enabled eSID this dri ing cycle (i.e. Auto start is only acti ated once per
dri ing cycle)
A new dri ing cycle starts if Ignition key is in OFF or if the dri er door is opened while the ehicle
speed is zero.
Welcome Message
The welcome message consists of a 64x64 orange pixel icon and two rows of text. The text lines can
be adjusted in the settings menu and the icon can be changed using an external tool together with a
CAN-interface. This tool is not finalized when this user guide is written so keep track on the website
and the Facebook page for latest status.
The welcome message will be shown when the dri er door is opened if any of the following
conditions has been fulfilled:
• eSID has been a sleep (car has been standing unlocked for a while)
• Dri er door has been locked and unlocked.

www.esid.se
Page:
9 / 43
Na
me of document:
eSID 03-06 User Guide
V
ersion:
1.2
Display
The display is di ided into 4 different segments:
1) Clock View – Shows the clock (12H/24H depending on Units configuration)
2) Icon View – Shows yellow or red icon
3) Main View – Here all the display groups/functions will be showed
4) Status View - Here some extra useful information will be isible to the dri er at all times
Main iew
The display functions in the Main View are structured in fi e display groups:
• Fa orites
o 5 selectable fa orite display functions from the other groups
• Powertrain
o Engine and transmission related display functions
• Vehicle
o Non-powertrain related display functions
• Diagnostics
o Read/Clear diagnostic fault codes
o Internal eSID debug data
o Software ersions
• eSID Settings
o The settings are sa ed when the eSID goes to sleep (i.e. locked car) and the alues
will then be remembered if the battery is remo ed.
o This menu is only enabled when the ehicle is standstill
1
2
3
4

www.esid.se
Page:
10 / 43
Na
me of document:
eSID 03-06 User Guide
V
ersion:
1.2
Status iew
The status iew is always isible when eSID is acti e and is intended to show information to the
dri er that is always of interest, information that typically has a slow update rate.
• Outside Temperature (C/F °)
• Dri e Time ( HH:MM )
• Actual Gear
(only Automatic Gearbox, when in Drive)
• Rain sensor acti e/inacti e (RS)
• eSID Wiper function acti e (W)
• DPF Regeneration Acti e (R)
(only 1.9 diesel engines with DP )
•
Acti e position in display structure
(P5 = Powertrain #5; 1 = avorite #1 etc.)
Display Units
eSID supports three sets of display units (it is not possible to mix between them):
• Metric
o Torque (Nm)
o Distance (km)
o Temperature (Celsius)
o Fuel (Liter)
o Fuel Consumption (L/100km)
o Boost (bar/bar)
o Clock (24H)
• Imperial UK
o Torque (Lbft)
o Distance (miles)
o Temperature (Celsius)
o Fuel (Liter)
o Fuel Consumption (MPG UK)
o Boost (bar/InHg)
o Clock (12H)
• US
o Torque (Lbft)
o Distance (miles)
o Temperature (Fahrenheit)
o Fuel (US Gallon)
o Fuel Consumption (MPG US)
o Boost (psi/InHg)
o Clock (12H)
The display units are changed in the normal SID settings (“Customize” --> )
Table of contents
Popular Industrial Monitor manuals by other brands

Dynamic Displays
Dynamic Displays QES1500 Progressive Series user manual

AXIOMTEK
AXIOMTEK Dk3g4PANEL 6153-O/P user manual

ESA
ESA XM7W7 installation manual

Siemens
Siemens SIMATIC Industrial Flat Panel IFP2200 Product information

Siemens
Siemens INOX PRO SIMATIC IFP1900 Compact operating instructions

Advantech
Advantech IDK-1115WP-45FHA1 user manual











