ESX VN815-VO-U1-DAB User manual

1
VN815-VO-U1-DAB
V1.2
INSTALLATION
GUIDE
VISION SERIES FOR ANDROID™
INFOTAINMENT
TOUCHSCREEN NAVICEIVER

2
IMPORTANT NOTES
This guide is an aid for the professional installation of the device.
Please note the following notes before installation:
• Always handle all parts of the device and the components of your vehicle with
care.
• Under all circumstances observe the regulations of the vehicle manufacturer
and do not make any changes to the vehicle which could impair driving safety.
• For safety reasons, disconnect the vehicle battery’s ground connection before
installation.
• Please always pay attention to the correct polarity of the connections.
• Please do not modify any harnesses or connections of the device or the vehicle
as this may affect the warranty.
• Make sure that no cables are squashed or cause a short circuit.
• Do not lay cables in front of the airbags, e.g. in the dashboard or in a way that
affects their function.
IMPORTANT NOTE FOR YOUR VEHICLE‘S SERVICE STATION
After installation of the ESX Naviceiver inside the vehicle, the device
is not recognized as the original radio and causes an error message
in the fault memory of the vehicle (depending on the vehicle, for ex-
ample „Infotainment CAN, no communication“). This error message
is normal in connection with our ESX device and can not be deleted.

3
RECOMMENDED TOOLS
Torx T25 screw-
driver or bit
Plastic mounting wedges Cable ties
VNA-RCAM-HI
Connection unit for original VW rear
Cam module with variable line display
VNA-RCAM-HI
VNA-RCAM-LO
Connection unit for original VW
rear Cam module with static line
display VNA-RCAM-LO
RECOMMENDED ACCESSORIES

4
SCOPE OF DELIVERY
ITEM FIGURE QUANTITY
Main device 1
System connector
QUADLOCK standard 1
System connector
POWER QUADLOCK 1
CAN-Bus decoder 1
USB adapter cable for
factory USB port 1
Antenna adapter Fakra on ISO 1
AV connector
with all audio and video
connections and
additional USB port
1
GPS antenna 1
DAB antenna 1

5
MICRO SD SLOT FOR NAVIGATION SOFTWARE
Here you can insert the MicroSD card of the navigation software. For the device
to have access, you may need to assign the access path in the Apps menu under
“Settings”.
If the device stops responding to input, the system is overloaded or crashed. Then reboot
the system by pressing the reset button (RES) on the front panel. Use a suitable object,
such as a paper clip or a ballpoint pen. After pressing the reset button, the system re-
starts without losing your previous settings.
RESET BUTTON

6
DAB antenna
WIRING DIAGRAM
15 A
9 107 86
12 1114 1315
4 52 31
17 1619 1820
11
10
12
9
13
8
14
7
15
6
16
5
17
4
18
3
19
2
20
1
1 BATTERY (+12V) 11 LIGHT CONTROL
12 STEERING GND
13 KEY1
14 CAN -TX
15 BRAKE CONTROL
16 FRONT LEFT OUT (+)
17 REAR LEFT OUT (+)
18 FRONT RIGHT OUT (–)
18 REAR RIGHT OUT (–)
20 GND (BATTERY –)
2 REAR RIGHT OUT (+)
3 FRONT RIGHT OUT (+)
4 REAR LEFT OUT (–)
5 FRONT LEFT OUT (–)
6 ACC +
7 REVERSE CONTROL
8 ANT/AMP CONTROL
9 KEY2 (SPARE BIT)
10 CAN-RX
1 VIDEO OUT 2 11 FRONT LEFT OUT
12 SUBWOOFER OUT
13 GND
14 AUX IN-LEFT
15 GND
16 AUX IN-RIGHT
17 GND
18 USB-DP
18 USB-DN
20 USB +5V
2 GND
3 VIDEO OUT 1
4 CAMERA IN
5 GND
6 AUX VIDEO IN
7 AMPLIFIER CONTROL
8 REAR RIGHT OUT
9 REAR LEFT OUT
10 FRONT RIGHT OUT
System connector
with device fuse
AV connector
System connector
with device fuse
AV connector
USB ports and external microphone port (optional)
GPS antenna
WiFi antenna
Radio antenna

7
INSTALLATION
Lift the sensor carefully, after you have slightly loosen the
left and right xings. Then disconnect the cable connec-
tor, but make sure that the connector slips not inside.
Carefully lift the ventilation grille and set it aside.
Remove the xing screw of the ventilation cover.
Remove the light sensor from the ventilation grille (de-
pending on model, if applicable) below the windscreen.
VOLKSWAGEN GOLF V (2003-2009)

8
INSTALLATION
Remove both screws (Torx 25) of the ventilation.
Carefully lift the ventilation frame upward, but only
a bit, the frame is still connected with the original
radio.
Carefully pry on both sides the upper panel from the
lower radio panel. Best is to use a plastic mounting
wedge to avoid scratching the surface.
Carefully lift the ventilation cover and set it aside.
VOLKSWAGEN GOLF V (2003-2009)

9
INSTALLATION
Remove both screws of the panel and loose the ra-
dio slightly.
Carefully remove the panel around the radio.
NOTE: The panel is held by 8 clips
Lift the upper panel a bit.
VOLKSWAGEN GOLF V (2003-2009)

10
INSTALLATION
Then disconnect the both antenna connectors (de-
pending on car and conguration) and the huge
car specic connector from the radio. If the original
Fakra antenna plug does not t mechanically into
the ESX device, we recommend the usage of an
adaptor.
After the remove of the original radio.
DAB+ GPS
Remove the 4 screws (Torx 25) which hold the ra-
dio. Then pull the radio out of the bay.
Mount the DAB antenna at the front passen-
ger windshield and route its cable inside the
A pillar to the center console. Also place the
GPS and lay its cable up to the center con-
sole.
VOLKSWAGEN GOLF V (2003-2009)