eufy Security HomeBase 2 User manual

Anker Innovations Limited. All rights reserved. eufy Security and eufy Security Logo are
trademarks of Anker Innovations Limited, registered in the United States and other
countries. All other trademarks are the property of their respective owners.
5100500XXXX V01
QUICK
START GUIDE
HomeBase 2

01
TABLE OF
CONTENTS
WHAT'S INCLUDED 02
PRODUCT OVERVIEW 03
POWERING ON HOMEBASE 2 04
ADDING TO EUFY SECURITY 05
06 ADDING OTHER DEVICES
06 NOTICE

02 03
WHAT'S
INCLUDED
For HomeBase 2 installation
HomeBase 2
(T8010)
Power
Adapter
Ethernet
Cable
Quick Start
Guide
PRODUCT
OVERVIEW
HomeBase 2
2
3
4 5 6
7
1
1. Status LED 5. Ethernet port
2. Speaker 6. SYNC/ALARM OFF button
3. Power port 7. Reset button
4. USB port
Metal Reset
Pin

04 05
POWERING ON
HOMEBASE 2
1. Power on and connect HomeBase 2 to a LAN port on your router.
2. Wait for a moment (up to 1 min) until the status LED turns blue.
ADDING TO
EUFY SECURITY
1. Download and install the eufy Security app, and sign up for an
account.
2. Add HomeBase 2 to your device list, and follow the in-app
instructions to complete the setup.

06 07
ADDING OTHER
DEVICES
Follow the in-app instructions to add your eufy Security devices to the
HomeBase 2.
NOTICE
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures: (1) Reorient or relocate the
receiving antenna. (2) Increase the separation between the equipment and receiver. (3) Connect
the equipment into an outlet on a circuit different from that to which the receiver is connected.
(4) Consult the dealer or an experienced radio/ TV technician for help.
FCC Radio Frequency Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The device can be
used in fixed/mobile exposure condition. The min separation distance is 20cm.
Notice: Shielded cables
All connections to other computing devices must be made using shielded cables to maintain
compliance with FCC regulations.
The following importer is the responsible party:
Company Name: POWER MOBILE LIFE, LLC
Address: 400 108th Ave NE Ste 400, Bellevue, WA 98004-5541
Telephone:[phone]
This product complies with the radio interference requirements of the European
Community.
Declaration of Conformity
Hereby, Anker Innovations Limited declares that this device is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU. For the declaration of
conformity, visit the Web site www.eufylife.com
Due to the used enclosure material, the product shall only be connected to a USB Interface of
version 2.0 or higher.
The adapter shall be installed near the equipment and shall be easily accessible.
Do not use the Device in the environment at too high or too low temperature, never expose the
Device under strong sunshine or too wet environment.
The suitable temperature for HomeBase 2 and accessories is -10°C-45°C.
The suitable temperature for eufyCam 2 and accessories is -20°C-50°C.
When charging, please place the device in an environment that has a normal room temperature
and good ventilation.
It is recommended to charge the device in an environment with a temperature that ranges
from 5°C~25°C.
Please ensure to use only the charger offered by the manufacturer. Using unauthorized charger
may cause danger and violate the authorization of the device and the guarantee article.
This charger is for indoor use only
The charger type is ASSA67W-120200, output voltage/current is 12Vdc/2A. The plug
considered as disconnect device of adapter. RF exposure information: The Maximum
Permissible Exposure (MPE) level has been calculated based on a distance of d=20 cm between
the device and the human body. To maintain compliance with RF exposure requirement, use
product that maintain a 20cm distance between the device and human body.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF
USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
SUB-1G Frequency range (for T8010): 866~866.8MHz ; Sub-1G Max Output Power (for
T8010):5.492dBm (ERIP)

08 09
Wi-Fi Operating Frequency Range:2412~2472MHz ; Wi-Fi Max Output Power:17.13dBm (ERIP
for T8010),17.47dBm (ERIP for T8114)
Anker Innovations Deutschland GmbH | Georg-Muche-Strasse 3-5, 80807 Munich, Germany
Anker Technology (UK) Ltd | Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11
2AA, United Kingdom
This product is designed and manufactured with high quality materials and components,
which can be recycled and reused.
This symbol means the product must not be discarded as household waste, and should be
delivered to an appropriate collection facility for recycling. Proper disposal and recycling helps
protect natural resources, human health and the environment. For more information on
disposal and recycling of this product, contact your local municipality, disposal service, or the
shop where you bought this product.
IC Statement
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired
operation of the device."
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement."
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
IC RF Statement:
When using the product, maintain a distance of 20cm from the body to ensure compliance with
RF exposure requirements.
Lors de l'utilisation du produit, maintenez une distance de 20 cm du corps afin de vous
conformer aux exigences en matière d'exposition RF.
Customer Service
Warranty
12-month limited warranty
Call Us
United States [phone] Mon-Fri 9am-5pm (PT)
United Kingdom [phone] Mon-Fri 6am-11am (GMT)
Germany [phone] Mo-Fr 6:00-11:00
Email Us
Customer Support: [email protected]
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
@EufyOfficial @EufyOfficial @EufyOfficial
FCC ID:2AOKB-T8010XIC:23451-T8010X