What the timer can do
Up to 16 ON/OFF periods can be set for each day of the week.
Any one period can be set between 1 Minute and 168 Hours
To simplify the setting of the day or days that are required there are a number of preset combinations of days within the programme.
They are as follows:
Every day of the week
Monday to Saturday inclusive
Monday to Friday inclusive
Saturday and Sunday only
Monday, Tuesday & Wednesday
Thursday, Friday & Saturday
Monday, Wednesday & Friday
Tuesday, Thursday & Saturday
Individual days of the week such as Monday etc
To Programme the Timer
Press the ‘Prog’ button & release it.
Set the day of days that you require the timer to operate from the list already described. The triangles at the top of the screen will show which
days have been selected.
Press the ‘H’ button to set the hour that you want the timer to operate at.
Press the ‘Min’ button to set the minute that you want the timer to operate at.
Press the ‘Prog’ button again and the OFF time can be set using the same method as setting the ON function just described above.
The timer will return to the master clock screen if no buttons are pressed for 30 seconds.
You have now set one ON/OFF period (#1).
To set additional periods press the ‘Prog’ button and then again to scroll to period#2 On , then again to #2 OFF and so to #16 if required.
To exit the programme function press the clock button this will return you to the master clock screen.
Enabling the programme to run
Press the ‘Manual’ button and the display will change from ON to ON-AUTO.
Pressing again will move to OFF and subsequent pressing will move to OFF AUTO and then again to ON.
To run the programme the timer needs to be set to either ON-AUTO or AUTO-OFF.
If you are setting the timer to run during a period when the timer is programmed to be off then the AUTO-OFF setting needs to be displayed.
If you are setting the timer to run during a period when the timer is programmed to be on the ON-AUTO setting needs to be displayed. IF ON
or OFF are displayed the timer will not operate to the programme set (see manual operation).
Cancelling programme periods
To cancel any programmed ON/OFF period. Press the ‘Prog’ button repeatedly until the Period number is shown that you wish to cancel or
change. Press the ‘C’ button and the screen will clear.
You will then be able to re-programme this period or leave it blank. Remember to clear both the ON and OFF instructions for any one period.
Resetting the timer clock
Pressing the button marked ’R’ will completely clear the master clock and all programmed periods in the memory of the device.
Manual Operation
Press the manual button to set the device to ON or OFF. This will override any programs that are set and force the timer into the set state ie
ON =on and OFF =off
Summer Time advance & winter time retard
Press the ‘D’ & ‘H’ button together and hold down for 10 seconds to move the master timer forward by one hour. |The display will show a ‘1h’
symbol in the top right hand corner.
Pressing the two buttons again will move the displayed time back and the ‘1h’ symbol will no longer be displayed.
Switching the timer off and clearing the menu
Pressing the ‘H’ & ‘Min’ buttons at the same time for ten seconds will switch the timer off. The clock settings and all programmed events will
be cleared. To switch back on press the small ‘R’ button.
Europa House
Airport Way
Luton, Beds, LU2 9NH
Tel: 01582 692 440 / Fax: 01582 692 450
website: http://www.europacomponents.com
Guide to the Programming Keys
Button ‘D’ Sets the Day
Button ‘R’ Resets the device
Button ‘Manual’ Sets the device to ON-AUTO-OFF
Button ‘C’ Cancels the last function
Button ‘ ’ Master clock
Button ‘Prog’ Enables Programming
Button ‘Min’ Set the number of minutes
Button ’H’ Sets the Hour
ET1624HD_Instructions:Layout 1 7/1/13 10:20 Page 2
