Evenflo Embrace Guide

Embrace™Handle Trigger
Replacement Instructions
1. Place and lock the handle in its lowest position then place the child restraint upside down with the handle pointing
to the left, as shown.
Handle
➚
1
3. Hold the handle securely and pry up
and out on the bottom of the trigger
until it pops free from the handle.
Note: You might have to use
some force to pop the trigger free.
2. Squeeze the left trigger (on your near
side) of the Embrace™. Insert the hooked
tip of the removal tool (supplied)
beneath the bottom of the left trigger,
as shown.
4. Remove the left trigger from the handle
and discard immediately.
Note: Do not remove the right trigger
at this time.
➚
Left Trigger
234
Left Trigger
Para instrucciones en Español, llamar al: 1-800-233-5921.
Fasteners (4)
Left Trigger (1)
2505-23
Right Trigger (1)
2505-24
Removal Tool (1)
2505-23
2505-24
Kit Contents:
Fasteners (4)
Left Trigger (1)
2505-23
Right Trigger (1)
2505-24
Removal Tool (1)
2505-23
2505-24
Left Trigger
Right Trigger
Left Trigger
Handle
Left Trigger
Handle
Handle
Removal
Tool
➚
Handle
Removal Tool (1)
Fasteners (4)
Left Trigger (1)
2505-23
Right Trigger (1)
2505-24

Handle
8. While holding the trigger in place,
insert one fastener through the inside
lower hole on the handle and into the
trigger, as shown.
Note: Push the fastener until it is flat
against the handle.
Place child restraint on its side then slide
the removal tool behind the handle and
beneath the fastener, as shown. While
holding the tool against the bottom
fastener, press the top fastener completely
into the hole with both thumbs.
Repeat steps 1 – 9 for the
right trigger (2505-24).
A video is available at
www.embracehandle.com.
9. While holding the inside fastener
in place, as shown, insert a fastener
through the outside hole in the
handle and rotate the fastener slightly
until it locks into place with the inside
fastener. Squeeze the two fasteners
together until both are flush with the
handle.
Note: You will hear an audible
“clicking” while the fasteners are
interlocking.
Important: Both fasteners should
be locked together, flat against the
handle. If they are, the installation is
complete. If there is a gap between
either fastener and the handle,
proceed to the TIP.
8 9
TIP
➚
New
Left Trigger
7. Squeeze the trigger until the green dot
is aligned in the upper hole, and the
trigger hole is aligned with the lower
hole in the handle, as shown.
6. Insert the new left trigger (2505-23)
into the handle.
Note: Make sure the side of the trigger
that says “THIS SIDE OUT” is facing to
the outside of the handle, as shown.
6 7
5. This replacement kit comes with a
new left trigger (2505-23) and a
new right trigger (2505-24).
Locate the part numbers to make sure
you have the correct new triggers.
2505-23
2505-24
Left Trigger Right Trigger
2505-23 2505-24
5
THIS
SIDE OUT
THIS
SIDE OUT
Handle and Trigger Holes
Aligned Here
Green Dot
25700139 5/07
Fastener
Fastener
Handle
Handle
Handle
Removal
Tool Fastener