Everybot Edge User manual

EDGE QUICK GUIDE
Ver 1.0 Copyright © 2019 Everybot Inc. All rights reserved
Main Unit
Remote Control:
with Battery
Power Adaptor Silicon Brush
Water Supply Mop Kit Mother Yarn Mops: Grey Microfiber Mops: Green
Mother yarn mop (grey color)
It is included with mother yarn which is 100times
thicker than microfiber. Thus, it is good for cleaning
up dust in cracks and stains.
Microfiber yarn mop (green color)
It is a mop with richer and longer yarns so it has
superior wiping performance.
Note
This is Not a Malfunction. Please Check.
Maintaining Water Supply Mop Kits
LED lamp is OFF
Sound alarm while its operation.
Components
LED ON
Blue Blinks
LED OFF
If you press a operation button for
2sec. LED lamp will be turned on with
power on status.
Aer 50minute cleaning, the main unit
sounds the alarm to change mops and
fill water in the water supply mop kit.
For the better cleaning, replace with
new mops and fill water aer charging.
If the machine does not work for 5min.
It automatically power o together with
LED lamp.
www.everybotweb.com
1 Separate the mop from the water tank
mop kit aer finished operating.
Please just pull out the water tank mop
kit by hands.
If it is hard to pull out, please twist it
a little bit.
2
Open the rubber cap to dry out inside
of water tank aer pour remained
water.
Please carefully review this guide before using the product
·
·
·
·
·
·
·
·

How to use & Charge Cleaning Modes
Please charge the product fully before
the first operation.
When charging the battery, the button on
the main unit and the remote control
does not work.
Do not use any other power adapter other
than the adapter which came with the unit.
Cautions
Yellow LED Blinks
Low Battery Level
Blue LED Blinks
Medium Battery Level
LED is OFF
Full Battery
Correct
Wrong
Correct Wrong
Cautions when using the product
Do not use unauthorized
adaptors.
* It may cause serious damage
for the product.
Please wash the mops with
detergent before of first using.
* Otherwise there could
be tainted problem.
Please separate the mop
from the water tank mop kit
aer finished operating.
* If the wet mops stay long
time on the floor, the floor may
be discolored or polluted.
Auto Cleaning Edge Cleaning Focus Cleaning Intensive Cleaning
‘Y’ Cleaning Step Cleaning Manual Cleaning50min.Cleaning
separate
separate
1
Wet mops throughly in water
and apply them in the main
unit aer wringing them out.
2
Attach the mop pads to fit
the joint parts to the holes
of the water supply mop kit.
3
Open the rubber cap of the
water supply mop kit and fill
the water into the water tank.
5
Press the operation button
more than 2sec. to turn on
the main unit.
6
Press the operation button
on the main unit or play
button of a remote control
to startthe machine.
4
Close the rubber cap of the water
supply mop kit and attach the water
supply mop kit into the bottom of
the main unit. Pressing it while turning
side to side will install it with a click sound.
·
·
·