Evolution Fury 5-S Installation guide

Fury 5-S - FAQ’s
___________________________________________________________________________
Dust Port Dimensions:
Base outlet
ID = 34.5mm OD = 39.5mm
Base to guard link
ID = 29.5 mm OD = 35.5mm
Guard
ID = 28.5mm OD = 35.5mm
__________________________________________________________________________
Adjust 90 Degree Stop:
Loosen this bolt to adjust the 90 degrees stop
___________________________________________________________________________
Table Dimension:
Without table extensions W= 560 mm x D= 580 mm
With table extensions W= 900 mm x D= 580 mm
Hight without legs H= 290 mm

Total Dimension Fully Assembles:
W= 900 x D= 890 x H= 820 mm
Blade Position:
Left to blade 495mm / Right of blade 395mm
___________________________________________________________________________
Fury 5-S set up
1, Rip Fence
2, Blade Adjustment
1, To check and adjust if require the rip fence
(A) Loosen the two-cap screw on the fence rail to the locking bracket. (M4 Hex Key required.)
(B) Level the opposite end of the adjustable rip fence with the T-Slot and hold in place.
(C) Pull or push the clamp end, to make it parallel with the slot.
(D) Then holding the rip fence in place with one hand, Lock the rip fence green handle.
(E) Re-tighten the cap screws.
2, Blade Adjustment,
(A) First remove the Blade guard
(B) Slide the rip fence up to the blade and check it is parallel.
(C) If not parallel, remove the table insert. This is a Philips screw at the front of the insert.
(D) Loosen the 2-counter sunk hex screws. (M4 Hex Key)
(E) You can then move the cross bar left or right, this will make the bade parallel with the rip fence.
1A 1B
1C 1D 1E

2A B
2C 2D 2E

___________________________________________________________________________
Table T-Slot Spec: